DASH DISASSEMBLY INSTRUCTIONS
1. Using a soft tool unsnap(pull towards rear) top dash panel on the driver side of dash,
located above radio and instrument cluster.
2. From the are now exposed, using a soft tool, pop up the instrument cluster trim bezel.
No need to completely remove.
3. Unscrew and remove shift knob.
4. Using a soft tool Gently unsnap and remove dash trim bezel, that includes the climate
controls and air vents and surrounds the radio.
5. Remove (4) 10 MM screws securing the radio mounting brackets
6. Remove factory radio and disconnect all wire harnesses.
23
DOUBLE DIN INSTALLATION INSTRUCTIONS
Figure A
KIT ASSEMBLY INSTRUCTIONS
Single ISO Mount Application
1. Insert pocket into lower section of the brackets and snap into rear pocket
support tabs.
2. Install brackets to rear of main frame using the (6) screws provided.
3. Insert ISO mountable radio between ISO mount brackets and loosely attach to sides
of radio using screws provided with radio when possible, or screws supplied with kit.
4. Using the main frame of the as a guide, slide radio forward or backward
for desired look and then tighten screws to the radio.
Note: Attach a rear support bracket to the rear of the new radio and adjust as
necessary to support the weight of the radio. Suggested
Double DIN ISO Mount Application
See Fig B for bracket tab removal.
1. Install brackets to rear of main frame using the (6) screws provided.
2. Insert ISO mountable radio between ISO mount brackets and loosely attach to
sides of radio using screws provided with radio when possible,
or screws supplied with kit.
3. Using the main frame of the as a guide, slide radio forward or backward
for desired look and then tighten screws to the radio.
Note: Attach a rear support bracket to the rear of the new radio and adjust as
necessary to support the weight of the radio. Suggested.
Figure B Remove shaded tabs
on left and right sides
of the brackets
(Right side not shown)
