ABCD PARADOX MAGELLAN User manual

30 Stuart St. Corner Brook, NL A2H 6R7
Phone: [phone] Fax: [phone]
and
USER GUIDE
30 Stuart St. Corner Brook, NL A2H 6R7
Phone: [phone] Fax: [phone]
User Codes
The system has 32 User Codes
•User # 1 is the System Master Code
•User # 2 and 3 are Master Codes
•Users 3 through 32 are User Codes
User code # 2 is permanently fixed to Partition 1 while user # 3 is permanently fixed
to Partition 2
How to Add/Modify a User
Press the POWER key
Enter the Master Code (Power & 1 will flash Lit numbers on keypad represent users already
programmed )
Enter the user number (01-32) (Armed flashes)
Enter a 4 digit code (Sleep flashes)
Re-Enter the code (Stay flashes)
Press the ENTER button (Off flashes)
If the system is partitioned, press 1 and/or 2 to assign the user to one or both partitions Press enter
Press the CLEAR button
Delete A User
Press the POWER key
Enter the Master Code
Select user (02-32)
Press & hold the SLEEP button until system beeps
Set Time/Date
Press TBL key
Enter Master Code
Press the POWER key
Press 5
Enter the time in 12 Hour format
Press (2 for AM) or (3 for PM)
Enter four digits for the year

30 Stuart St. Corner Brook, NL A2H 6R7
Phone: [phone] Fax: [phone]
Enter 2 digits for the month (01-12)
Enter 2 digits for the day (01-31)
Press CLEAR
Setting Chime Zones
Press and hold the key representing the zone (1 for zone 1 etc ) until the keypad
beeps
To turn the chime off, repeat the above procedure
Trouble Display
If the TBL light is on and the Keypad beeps every 5 seconds press the TBL key to stop
the beeping The keypad will then illuminate a number corresponding to the associated
trouble
1 Call for Service
2 Power Trouble Press 2 to find out what type
1) Main Battery Low
2) AC failure on main panel
3) Auxiliary power failure from the control panel
3 Siren Problem
4 Telephone Communication Problem
5 Zone wiring problem
6 Module has been tampered with
7 Call for Service
8 Clock has lost the correct time Reset the time
9 Call for Service
10 Module Failure A device is no longer communicating with the control panel
Arming and Disarming
To arm the system close all zones Press ARM and enter User Code
If you have access to both partitions press the desired partition(s)
Sometimes a zone may have to be ignored when the system is being armed This
could be for any reason but a zone can be bypassed
To bypass a zone, press BYP and enter User Code The BYP light will flash Press the
zone(s) which you wish to bypass until they start to flash Press ENTER
30 Stuart St. Corner Brook, NL A2H 6R7
Phone: [phone] Fax: [phone]
To Disarm the system press OFF and enter your User Code
F RE ALARM
Resetting a Fire Alarm
If a fire alarm was set off accidentally press the CLEAR within 30 seconds You will
now have 90 seconds in which to correct the problem If the problem is not corrected
in 90 seconds the alarm will sound again Press CLEAR to extend for another 90
seconds