AbleCon AS Page 4 of 13 ASSEMBLY INSTRUCTIONS
Produkt verojon: ABLEBABY RAZER ver. 1.2 – 14.05.2021
Contakt info: www.ablecon.no service@ablecenter.no support tlf: +47 40082011
System requirements
To use AbleBaby B Razer, the following system requirements must be met
PC with Windows 10 operating system and USB 2.0 port or higher.
Feel free to contact our technical support by phone 40082011.
Assembly
AbleBaby ™ is a small portable camera system that consists of
a tripod that is easily mounted on the table with a clamp. The
tripod has a magnet at the end that makes it easy to attach
the camera. Move the camera towards the magnet with the
metal plate facing the magnet.
When the camera is connected to the tripod, insert the cable
with the USB plug into an available USB port on the PC. The
camera receives power, and the image stream is routed to the
machine through the USB cable quickly. This is all that is
needed to get started. If you need this system in several
locations / classrooms, then you may want to have several
arms set up in several places. In this way, you only need to
take the camera with you. This camera is no bigger than you
can put it in your pocket.
AbleBaby ™ is a system that aims to solve work up-close, such as
reading and writing assignments, needlework etc. If you need
magnification of distance measurements, then this small camera
system can easily be combined with AbleCenter®, AbleCenter®
Compact, or AbleMove ™.
AbleBaby ™ Razer has a camera equipped with lighting and an
option to tilt the camera into the room. It provides a certain
opportunity to capture camera targets that are located elsewhere
than on the table.
