Using your kettle
6
It is recommended that you boil the kettle several times following the below
instructions and discard the water before first use. This will remove any loose dust
or materials that may have remained from the manufacturing process.
1. Open the lid and fill with water. Fill to the required level and close the lid. We
recommend you fill to the maximum line for first use and discard the water as
suggested above.
2. Always fill the kettle between the MIN and MAX lines. If you fill below the MIN
line the kettle may run dry and you may damage the heating element. If the
kettle runs dry the safety cut-out will operate and the power will be removed
from the element to prevent possible damage. To reset, allow the kettle to cool
down or carefully add water. If you fill above the MAX line, then boiling water
may be ejected from the spout.
3. Insert the mains plug into a suitable 13 Amp mains socket.
4. Press the power switch to the ON position ‘I’. The power light will light up.
When the water has boiled the kettle will switch off automatically. Avoid lifting
the kettle from the base while boiling.
For Customer Services & Spare Parts please call 0845 209 7461
Opening times: Monday - Friday 9am –5pm & Saturday 9am –1pm or visit us at www.productcareuk.com
