Abtus AV544 User manual

LCD/LED Display
Wall Mount
Model: AV544
SPECIFICATION
* Specifications are subject to changes without notice.
ABtUS SINGAPORE PTE LTD www.abtussingapore.com
** For detail, updated Command Code and Application Software, please visit and download from www.abtussingapore.com
DIMENSION OVERVIEW
mm inch
A230 9.06”
B 50-200 1.97”-7.87”
C 50-200 1.97”-7.87”
D 230 9.06”
E110 4.33”
F115 4.53”
Model Name AV544
LCD/LED SIZE Suitable for 17” to 32”
GROSS DIMENSION 250 x 250 x 25 (mm)
GROSS WEIGHT 950 g
VESA MOUNTING HOLES 50 x 200 Max
DISTANCE FROM WALL 15 mm
LOAD CAPACITY 20 Kgs
COLOUR OPTION Black

User Operation Guide
INSTALLATION
1). Do not over tighten screws during installation. Over tightening can cause damage to the
screws and greatly reduce their ability to support the weight of the display.
2). Ensure that the mounting screws are anchored to the center of studs. Use of
an “edge to edge” stude finder is highly recommended.
Step 1:
Drill holes onto the wall and put 8x40 Concrete anchor
(E) in the holes. Fit the wall board to the wall using ST5X40
Lag bolt (D) as above / right fig.
Keep the bubble level aline.
Step 2: Mounting the TV set to the TV board
Using A-C bolt packed in accessories package, mount the screen to the TV board.
Put in the screws (A-C), then fix them to the TV mounting holes as shown below.
Step 3: Putting the wall mounted TV board
with screen to the wall board
Hand the TV set mounted on the TV board (G) to the
wall board (F). Please see as right fig.
PACKAGING CONTENT
1). Do not begin the installation of this product until you have read and fully understood the instructions
and warnings contained in this installation sheet. If you have any questions regarding any of the instruction
or warning, please contact your local distributor.
2). Please refer to the manufacturer’s installation guide on recommendation for required distance from
the wall to avoid risk of property damage.
3) This product should only be installed by someone when good mechanical knowledge.
4). Make sure that the supporting surface can safely support the combined load of the equipment and all
attached hardware an components.
5). Never exceed the Maximum Local Capacity.
6). When mounting onto wooden wall studs, ensure that mounting screws are anchored into the center
of the studs Use of an “edge to edge” stud finder is highly recommended.
7). This product intended for indoor use only. Installing this product outdoors could lead to product failure
and personal injury.
WARNING
Item
ABolt M5x16 4 sets
CBolt M8x16 4 sets
Item
DLag bolt St5x40 3 sets
Item
EConcrete anchor 8x40 3 sets
Item
FWall Mount 1 set Item GTV Bracket 1 set
* Specifications are subject to changes without notice.
** For detail, updated Command Code and Application Software, please visit and download from www.abtussingapore.com