Access HD DTA1010 User manual

Rev. June 5, 2008 Access HD® is exclusively distributed by GXi International, LLC Page 1 of 2
CONNECTING YOUR DIGITAL CONVERTER BOX
Connect the antenna to the ATSC (RF IN) jack on the back of your converter box.
Using the supplied RF Coax Cable, connect the NTSC (RF OUT) jack on the
back of your converter box to the ANTENNA IN jack on the back of your TV.
(NOTE: You may also connect converter box to TV with optional RCA Audio/Video Cable)
Connect the power cord into a power outlet or surge protector.
Turn ON the converter box and TV.
Set your TV to Channel 3 (or 4) to match the CH3/CH4 switch on the back of
the converter box.
Quick Start Guide DTA1010
2
3
1
2
3
4
5
1
5

Rev. June 5, 2008 Access HD® is exclusively distributed by GXi International, LLC Page 2 of 2
Please verify the following:
• The batteries are correctly installed in the
Access HD remote control.
• The TV is ON and the digital converter box is
powered ON (Green LED/Light lit on front panel)
• The converter box and your TV are both set to
Channel 3 (or both 4).
Initial Setup Menu
2. Set the Time Zone:
• Press ▼to select Time
Setup
• Press ►to set your Time
Zone (Pacific, Alaska,
Hawaii, Eastern, Central,
Mountain)
1. Set the Menu Language:
• Press ►to set your
Language
(English, Spanish, French)
3. Auto Program Channels:
• Press ▼to select Auto
Channel Searching
• Press ►to begin
automatically searching
for channels
• It will Perform a Fast Scan (1-2 minutes)
• It will then Perform a Digital (Deep) Scan
(4-6 minutes)
• Please be patient, as this complete
process takes from 5 to 8 minutes
• DO NOT INTERRUPT THE PROCESS
• Once the Auto Channel Searching is
finished, it will automatically exit and
display the first channel found