Accolades BPFDLG User manual

Two Person Assembly
Recommended
STEP 1
Mount legs to the shelves using the supplied screws.
Use the larger screws in the outside holes & the smaller screws in the inside holes.
Do not fully tighten until all of the screws are in place.
(Tighten until snug - do not over tighten).
LARGER SCREW
LARGER SCREW
SMALLER SCREW
SMALLER SCREW
4 Shelf Floor Display Lifeguard Chair
#BPFDLG
ASSEMBLY INSTRUCTIONS
Two Person Assembly
Recommended
4 Shelf Floor Display Lifeguard Chair
#BPFDLG
ASSEMBLY INSTRUCTIONS

STEP 2
Mount arms to the legs using the
supplied smaller screws.
Do not fully tighten until all of the
screws are in place.
(Tighten until snug - do not over tighten).
Slide backer down the channels & into place.
STEP 3
Mount life preserver to the right side of the chair using the included zip-ties.
Loop the zip tie through the rope on the life preserver and the pre-drilled holes in the legs.
Pull the zip-tie snug and snip the excess off.
SMALLER SCREW
ZIP-TIE
Two Person Assembly
Recommended
4 Shelf Floor Display Lifeguard Chair
#BPFDLG
ASSEMBLY INSTRUCTIONS