Ace ACE.BOIL User manual

WATER SYSTEM S
ACE.BOIL Water System
1-12-23-8
9-910-12

1
IN
OUT
X 1
X 1
X 2
X 1
X 1
AB
X 1
X 1
X 1
X 1
X 1
(Unit: mm)

2
IN
OUT

3

4
1
2
A.
A.
B.
B.
C.
3
34
>35
G 3/8
G 3/8
G 3/8

5
G 3/8
G 3/8
G 3/8
125
Min.65
G 1/2
G 1/2
G 3/8
G 3/8
4
Filter model S V XL 2XL
Diameter(D) 88 115 145 185
G 3/8

6
5
6A.
B.
min. 10cm
G 3/8
G 1/2
G 3/8

7
7
B.
A.
C. D.
E. F.
2 min

8
8
0
1
C. D.
0
1
A. B.

9
9
A. B.
10
AB.

10
ACE.BOIL water system
Dispensing water types Boiling water, cold/hot tap water.
Boiling water tank capacity 4.4 Litres
Heating-up time 15 minutes (from 20oC to 100oC)
Min./Max. mains pressure 2/5 bar (200/500 kPa)
System max. safety pressure 8 bar (800 kPa)
Max. hot water temperature 100oC
Operation Operation via mechanical control knob, handle
Power supply 230VAC/50Hz
Max. power consumption 1550 W
Standby power consumption 0.35 W
Safety features Maximum temperature fuse, Safety valve(with a cut-off, relief valve ,a built-in non-return valve)
Tank Dimensions 219mm x 366 x 279(L x H x W)
Empty tank weight 4KG
Full tank weight 8.4KG
Flow rate 2.5 L/min
Max. water hardness 10° dH
Read this document before installing and operating this product. Users are required to be familiar with all the information and applicable
standards prior to installing and using this product. This manual should be saved for future reference and use.
• Ambient conditions requirements: Relative humidity: 25%~90%; Storage temperature: -20oC to 60oC(-4oF to 140oF); Operation
temperature: 4oC~50oC(39.2oF to 122oF).
• Do not install the unit near heat sources or an open fire. Unit environment should be well-ventilated.
• Inform people who are unfamiliar with the ACE.BOIL water system about safe use, incorrect use may result in injury.
• Consult a service technician if the ACE.BOIL water system does not operate normally when you have followed the instructions in this
manual.
• Filter is optional, a filter can be fitted in order to lower the water hardness, filter the content of the water for hygiene reason and
extending the product,s lifetime. Filter can be ordered online at the website http://www.ace-watersystems.com.
• Filter with water softener is mandatory to use when water hardness exceeds 10 odH.
• Do not attempt to repair this product yourself. Always get an ACE qualified service technician to carry out adjustments or repairs.
• Whenever a power cord is used, it should be certified by local and national standards and used under guidance of an authorized
technician.
• The ACE.BOIL water system may only be installed according to the instructions in this manual. Incorrect installation of the unit
may cause damage to property. Do not use any extension hoses other than those supplied with the unit or supplied by ACE Water
Systems.
• The power supply cord and On-Off Power button are used to connect and disconnect the unit from power. Ensure that the socket
outlet and knob are accessible after installation.
• Overloaded AC outlets, extension cords, and broken plugs are extremely dangerous. They may result in electrical shock or fire
hazard. Call an authorized service technician for any replacements.
• Hands must be dry when plugging the power cord in or out of the AC outlet to prevent electrical shock. Do not damage the power
cord by disassembling, bending, pulling or exposing it to heat as this may cause a fire or electric shock.
• Make sure to completely insert the power plug into an AC outlet. Insecure connections can cause fire.
• Ensure that the power source is grounded correctly. Do not use extension cables and adapters between boiler and power source.
• Unplug the unit whenever it is not in use for an extended period of time.
Product safety precautions
Technical Specications
Caution!
After assembling the water system and before turning on the power, please hold the boiling water knob open till water
flows out from faucet outlet, then connect power, turn the Power button to“On”position to start the water heating.
Warning: Use caution when dealing with boiling water. Children should not touch the device. Cleaning and user
maintenance must not be carried out by children without supervision.
Note:Inareawherethewaterhardnessexceeds10°dH(Germanhardness),itisrequiredtouseanACElterwithwatersoftener.

11
Service should be performed by qualified and authorized personnel only.
Warning: DisconnectthepowersupplyfromtheACE.BOILwatersystembeforecarryingoutmaintenanceonit。
• Keep the ACE.BOIL water system in a dry, clean space. Minimize exposure to dust. Power button or other controls should never be wet.
• If the unit gets wet, power it off immediately. Wait for the unit to dry completely before powering it on again.
• Clean exterior surfaces of the unit with a soft, lint-free cloth. Never use alcohol, paint thinner, benzene or other solvents to clean this
unit. Never use an abrasive material such as a brush or scouring pad to clean surfaces.
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Wipe surfaces clean after applying cleaner.
• Never expose the unit to vibration.
• Ensure that all cabin ventilation outlets are always free.
• In the event of mechanical/power failure or damage, do not attempt to repair the system unit or wires. Refer all such problems to an
authorized technician.
• If the ACE.BOIL water system needs service, please consult the authorized dealer, unauthorized service may void the warranty.
• Close/open system valve and safety valve every 6 months.
• Clean aerator once a year.
Regular maintenance of the ACE.BOIL water system can help prevent damage or downtime.
Read and follow assembly instruction. If the ACE.BOIL water system does not functioning properly please check troubleshooting table. If
the water system still not working properly, disconnect it and contact authorised ACE customer service for assistance. When calling for
assistance please provide your product model and serial number.
Care and Maintenance
Troubleshooting
Symptom Possible Cause Solution
No water owing, the water is
owing too slowly.
- Main water supply valve is turned off.
- Safety valve is turned off.
- Turn on the main water supply valve.
- Turn on the Safety valve.
-Noconnectionbetweenfaucet,boiler,lter
and Safety valve.
- Connect all the cable and hose correctly.
- Filter is not installed correctly. -Tightenlter.
- Hoses are kinked. - Check whether hoses are kinked.
- There is limescale or dirt in the aerator. - Clean/replace the aerator.
The water is sputtering or is
irregular.
- There is no or too little water pressure. - Check the water pressure. It should be above 1.0 bar. Check
a different tap. If the pressure is also low there, check the
mains water tap and contact your water supplier.
No boiling water
- The boiler is powered off or not connected to
power supply wall socket(Red LED light is off.).
- Connect to power supply wall socket and press the Power
button on the boiler to power on it.
- The boiler has not yet reached the correct
temperature.
- Check whether the red light is blinking and wait until the red
light is lit up.
- Current limit fuse is burned out and cut off
electric power due to over current.
- Check the fuse and if found to be burned out , replace fuse
with a new one, see below picture A/B.
- Faulty cables/hoses - Contact ACE Water Systems service.
- Faulty Safety valve - Contact ACE Water Systems service.
- Faulty function of boiler. - Reset the boiler by pressing the Power button to "Off" position
and back to "On" position after 30 sec..
A. B.

12
Limited Warranty
1. Warranty Period & Coverage
• This product has been manufactured and tested to the highest quality standards by ACE Water Systems, and comes with two-
year warranty from the date of purchase.
• This warranty covers only your ACE Water Systems manufactured product. Limited warranty is applicable to defect in material or
workmanship as follows: Within warranty period, ACE Water Systems will repair or replace any part of the product that proves
defective because of improper workmanship and/or material, under normal installation, use, service and maintenance. There will be no
charge for parts and labor.
2. The conditions
The system,s warranty will be invalidated as a result of:
• Using the unit in any manner without following the instruction manual.
• Misuse, abuse, mishandling, misapplication, alteration.
• Negligence, failure to maintain environmental conditions specified by the manufacturer, wrong attempt to relocate the system.
• Malfunctions caused by faulty installation, improper maintenace.
• Damages caused by user or a third party.
• Unauthorized service, repairs, modifications to the unit.
Note: ACE Filter with water softener should be used for water harder than 10° dH. Water softener should be replaced once reaches its end
of life. Fail to comply with it will void warranty.
3. Warranty exclusions
The items listed below are excluded from free repair or replacement:
• General/normal wear and tear.
• Conditions in the home such as excessive water pressure or corrosion.
• Defects that do not affect considerably the usage or the character of the unit.
• Defect or damage caused by an home accident like lightning damage, power surge issues with electrical stability
• Damage resulting from improper maintenance or severe contamination.
• Cosmetic damage, scratches, scrapes and dents.
• Use ACE Water Systems domestic unit for professional use.
4. Charging
• If no malfunction can be detected or found by service technician based on its description, you will be charged for call out costs and an
hour of labour according to the rates that apply at that time.
5. To obtain warranty parts or information
• Contact your ACE Water Systems retailer or contact technical service.
• In requesting warranty service, you will need to provide: 1. The sales receipt or other evidence of the date and place of purchase. 2.
A description of the problem on the unit. 3. Delivery of the product or the defective part, postage prepaid and carefully packed and
insured.
• Receipt for ACE filter and softener purchased when required as per ACE Water Systems manual instructions.
• For further information, please look in our website http://www.ace-watersystems.com.
ACE.BOIL water system must be disposed as per the local laws and regulations applicable to that location. Once the product reaches end of its
life cycle and needs to be disposed, local authorities should be contacted for appropriate options.
This symbol on the product or in the manual means that electrical or electric equipment should be disposed at the end of its life-
cycle separately and not in the regular household waste. There are separate collection systems for recycling in the EU. For more information,
please contact your local authorities or your retailer where you purchased the product.
Disposal
Disclaimer
All the information, design and specifications contained in this manual were correct in this publication. However, as the product goes
under continuous upgrades and changes, the final device may have slight differences. The contents of this manual are subject to changes
without prior notice, and ACE Water Systems shall not be liable for any errors contained herein or for incide or consequential damages
in connection with the furnishing performance, or use of this manual.
© 2018 UNITO SMART TECHNOLOGIES LTD. All rights reserved.
The information contained in this user manual and all accompanying documentation is copyrighted and all rights are reserved. This publication
may not be copied for commercial purposes in any form, in whole or in part without the prior written consent of ACE Water Systems.
The ACE Water Systems logo is a trademark of UNITO SMART TECHNOLOGIES LTD., use of ACE Water Systems logo for commercial
purposes without the prior written consent of the company may constitute trademark infringement.