Acetech VOB500 User manual

1
USB VoIP Adapter
Quick Guide

2
Installation
The following instructions will guide you to through the
process of installing the Personal USB Adapter.
STEP 1: If Skype™ is not already installed on your
co puter, visit http://www.skype.co and follow
the instructions there to install Skype™. Verify that
Skype™ is working before installing the USB
Adapter.
STEP 2: Insert the supplied CD-ROM into your PC
CD-ROM drive. The installation should start auto atically.
If not, open the installation folder on the CD-ROM and
double click on the setup.exe progra as shown below.
After the instllation, connect the USB cable to the USB
Adapter’s “USB” port as shown below:
The other end of the USB cable ust be connected to a
USB port on your co puter or to an AC Powered USB

3
hub.
T e USB Adapter MUST not be connected to a bus
powered USB ub.
STEP 3: You would then see following screen if your
Skype is already running. If not, start your Skype
progra . Refer to STEP 1 for how to download the Skype
progra .
Choose the first option “Allow this progra to use
Skype”, and press OK. Following Dashboard screen
should appear, showing Skype is connected.
STEP 4: Connect a standard telephone handset (either
corded or cordless) to the USB Adapter’s port “PHONE”

4
using a telephone cable as shown below
STEP 5: Connect a telephone cable between the USB
Adapter’s port “PSTN” and a wall jack as shown below.
Note that this is only required for aking regular phone
calls or for Diverting Skype calls to your obile (or other
off-site) phone or for toll bypass applications.
USB Adapter States
Adapter is running properly:
Adapter is not running. Please check if the USB Adapter

5
is properly connected to the PC.
When the USB Adapter progra is not running, there is
no phone in the syste tray.
USB Adapter LED
Power LED: Indicating the USB Adapter is receiving
power.
VoIP LED: When the USB Adapter is switched to
VoIP(Skype) network, it will be lit. When there a VoIP
(Skype) call, the light will be blinking.
PSTN LED: When the USB Adapter is switched to PSTN
(landline) network, it will be lit. When there a PSTN call,
PSTN LED
VoIP LED
Power LED

6
the light will be blinking.
Both VoIP and PSTN LED xwill be lit when the USB
Adapter is diverting call, or when the 3-way
conferencing is enabled.
Making and Receiving Calls
You can continue to use the telephone handset
connected to the USB Adapter to ake and receive
standard telephone calls as you used without any
change. To ake a standard phone call, just pick up the
handset and dial as you nor ally would.
To answer the call, just pick up the handset and speak as
you nor ally would.
Making a SkypeOut Call
Step 1: Press *#*
Step 2: Press 00 + country code + telephone nu ber (e.g.
001 617 555 1212) + ##
Making a Skype Call
Step 1: Press *#*
Step 2: Press “Speed Dial of the User” (e.g. 10) + ##

7
Setting Skype Speed Dial
Right click on the desired contact as shown below and
select “Assign Speed-Dial” under Skype:
Note: There are different dial tones for PSTN and
VoIP/Skype. You can switch forward and back between
PSTN and VoIP/Skype through pressing “*#*”

8