Action Sports S000521T Maintenance manual

Action Sports Equipment Pty Ltd.
72 Silverwater Rd, Silverwater, NSW, Australia, 2128
Parts & Service Enquiries: 1800 465 070 (Australia); 09 477 6020 (New Zealand)
Sales Enquiries: 1800 777 137 (Australia); 09 477 6020 (New Zealand)
Or visit our website: www.actionsports.com.au
4-Unit Swing Set
Model: S000521T
Assembly, Installation, Care, Maintenance and Use Instructions
IMPORTANT
Please read and retain this manual as it will assist with identification for parts and service.
Read these materials prior to assembling and using this swing set.
This Product is for Domestic Use Only.
- Warning -
- This swing set is for family domestic use only.
- This swing set is designed for use by children 3-9 years of age weighing no more than 34kgs.
- This swing set has a maximum weight limit of 204kgs.
- Children of all ages must be supervised by an adult at all times when using this swing set.
- Adult assembly of this swing set is required. Two adults are recommended for assembly.
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:1

- WARNING -
1) Read and understand enclosed safety information before assembly and use of the swing set.
2) Place the swing set on a level and soft surface before use.
3) Lateral clearance is essential. The swing set should be placed not less than 2m (6 feet 6 inches) from any
structure or obstruction ie. a fence, garage, house, shed, overhead branches, clothes line etc.
4) DO NOT install this swing over hard surfaces such as concrete, asphalt or any other hard surface.
5) It is recommended that this swing set be positioned over soft lawn or fine sand.
6) Anchor the swing set using the wiggling anchor pegs provided to prevent overturning or lifting. The anchors
should be placed level with or under the ground in order to reduce the tripping hazards.
7) Never place the swing set under or near powerlines.
8) Never place the swing set inside a garage or basement or under any structure.
9) Always position the swing where it can be seen from the house.
10) This swing set is designed to be used by one child per seat at one time.
11) Do not allow additional items to be attached to the swing set such as ropes, chains, cords, or other items not
designed for use.
12) Do not use the swing set when it is wet as it will become slippery and serious injury may result.
13) Do not wear apparel such as hats with chin straps, helmets, scarves, garments with pull strings and other items
of loose clothing while using this swing set as they can cause serious injury.
14) Do not walk close to, in front of or behind the swing set when in use. Walking between moving rides can
cause serious injury.
15) Do not jump from the swing set when they are in motion.
16) Do not stand on the seats when using the swing set.
17) Do not climb on the side braces or the top support of the swing set.
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:2

TABLE OF CONTENTS
TABLE OF CONTENTS.................................................................................................................3
PARTS LIST – MAIN FRAME.......................................................................................................4
PARTS LIST – SLING SWING ......................................................................................................4
PARTS LIST – TRAPEZE...............................................................................................................5
PARTS LIST – GLIDE RIDER .......................................................................................................5
PARTS LIST – LAWN SWING.......................................................................................................6
PARTS MATCH LISTS – 1:1 Actual Scale.....................................................................................7
ASSEMBLYAND INSTALLATION INSTRUCTION ................................................................11
SECTION 1- MAIN FRAME ASSEMBLY..................................................................................12
SECTION 2- LAWN SWING ASSEMBLY..................................................................................13
ECTION 3 - SLING SWING ASSEMBLY...................................................................................14
SECTION 4 – TRAPEZE ASSEMBLY ........................................................................................16
SECTION 5 – GLIDE RIDER ASSEMBLY.................................................................................17
SECTION 6 – ANCHOR PEGS....................................................................................................18
MAINTENANCE INSTRUCTION...............................................................................................19
CAUTION......................................................................................................................................19
LIMITED WARRANTY…………………………………………………………………………20
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:3

PARTS LIST – MAIN FRAME
Parts # Parts Description Quantity
MF-1a Top Support Tube A
1
MF-1b
Top Support Tube B 1
MF-1c
Top Support Tube C 1
MF-2
Top Support Tube
Brace 2
MF-3
Leg Stay 2
MF-4
Upper Leg Tube 4
MF-5 Lower Leg Tube 4
MF-7
Anchor Peg 4
PARTS LIST – SLING SWING
Parts # Parts Description Quantity
SS-1
Sling SwingAssembly 1
SS-2
Eyebolt Assembly
(built- in to SS-1) 2
X-6
Oval Opening Cap
(built-in to SS-2) 2
X-16
Plastic Lock (built-in to
SS-2) 2
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:4

PARTS LIST – TRAPEZE
TZ-1
Trapeze Assembly 1
TZ-2
Eyebolt & Link
Assembly (built-in to
TZ-1)
2
X6
Oval Opening Cap
(built-in to TZ-2) 2
X16
Plastic Lock (built-in to
TZ-2) 2
PARTS LIST – GLIDE RIDER
Parts # Parts Description Quantity
GR-1
Glide Rider Upper
Hanger Tube 2
GR-2 Glide Rider Lower
Hanger Tube 2
GR-3 Glide Rider Seat Tube 2
GR-4
Glide Rider Seat 2
GR-5 Glide Rider Foot Step 2
X3 Bracket 4
X6 Plastic Bearing 2
U3 T-Shaped Washer 4
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:5

PARTS LIST – LAWN SWING
Parts # Parts Description Quantity
LS-1
Lawn Swing Upper
Hanger Tube 2
LS-2
Lawn Swing Lower
Hanger Tube 2
LS-3 Lawn Swing Armrest
Tube 4
LS-4 Foot Plate 1
LS-5 Seat and Back Plate 4
X3 Bracket 8
X4 Plastic Bearing 4
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:6

PARTS MATCH LISTS – 1:1 Actual Scale
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:7

© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:8

©
ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:9

© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:10

Tools included in the Item
Wrench Allen Key
A socket set and adjustable spanner may also be used to further assist in swing assembly.
- IMPORTANT -
Use this parts list to make sure all parts are present before assembly. Do not attempt to
assemble the swing set if any parts are missing or damaged. Disassemble the Swing Set
immediately if any part is missing or any unsafe condition exists. Obtain a replacement
part to properly correct the hazard by calling 1800 465 070 (Australia) or 09 477 6020
(New Zealand). Do not allow use of the swing set until the hazard has been corrected.
ASSEMBLYAND INSTALLATION INSTRUCTION
Read this entire assembly section before beginning to assemble your swing set. Carefully follow each
step.
NOTE: At least 2 persons are recommended for the following assembly.
In order to avoid injuries and damage to property, it
is recommended that the Swing Set should be at
least 2 metres away from any buildings, fences and
so on. Also clear the ground of any sharp objects.
Use the Parts List to make sure all parts are present. Contact Customer Service at 1800 465 070
(Australia) or 09 477 6020 (New Zealand) if any parts are missing. Do not attempt to assemble the
swing set if any parts are missing.
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:11

SECTION 1- MAIN FRAME ASSEMBLY
Note: At least two people are required for the assembly of the swing set.
Caution: The swing set should be placed on a soft surface, such as a grassed lawn area is
recommended.
1.1 Lay out the top frame on a soft and level surface as Fig. 1.Align holes, connect the Top Support Tubes
(MF-1a,b,c) and the Top Support Tube Braces (MF-2), using Bolts, Washers & Nuts ofA2 & A3. See
Fig.2
Figure 1
Figure 2
1.2 Slide the Lower Leg Tubes (MF-5) into the Upper Leg Tubes (MF-4), align holes. Put the Leg Stay (MF-3)
onto the leg tube. Align holes and fasten with Bolts, Washers & Nuts of A1. See Fig.3
Figure 3
1.6 Secure the completed Leg Tubes to the Top Support Tube Braces (MF-2) with Bolts, Washers & Nuts of A3.
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:12

Make sure the welded sockets on the netted leg tube are pointing outwards of the swing set. See Fig. 4.
When it is completed, the swing set main frame will look like as Figure 5.
Figure 4
Figure 5
SECTION 2- LAWN SWINGASSEMBLY
Attach the Lawn Swing to the Main Frame as shown Figure 6.
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:13

Figure 6
ECTION 3 - SLING SWINGASSEMBLY
Attach the Swing Seat to the Main Frame as shown Figure 7.
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:14

Figure 7
WARNING!
DO NOT OVER TIGHTEN EYEBOLTS!
THIS CAN RESULT INASSEMBLY FAILURE!
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:15

SECTION 4 – TRAPEZEASSEMBLY
Connect the Trapeze to the Main Frame as shown in Figure 8.
Figure 8
WARNING!
DO NOT OVER TIGHTEN EYEBOLTS!
THIS CAN RESULT INASSEMBLY FAILURE!
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:16

SECTION 5 – GLIDE RIDER ASSEMBLY
Attach the Glide Rider to the Main Frame as shown in Figure 9.
Bracket Assembly
Figure 9
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:17

SECTION 6 –ANCHOR PEGS
Secure the 4Anchor Pegs (MF-7) to the Swing Set legs, using theA4 Nuts. Push the whole peg into
the ground as shown in Figure 10.
Figure 10
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:18

MAINTENANCE INSTRUCTION
To maximise the life of your swing set, make sure your children enjoy your swing
sets safely. It is important to check and inspect the following regularly before
each use of the swing set, and carry out necessary maintenance immediately.
Nuts and Bolts: Check before each use for tightness and tighten if required. Replace any damaged,
distorted or missing fasteners immediately.
Plastic components: Check before each use for deterioration.
Replace immediately if cracked or damaged. Use only genuine Action’s replacement parts.
Metal components: Check before each use for corrosion, cracking, tears, distortion or other damage.
Replace immediately if these conditions exist. In particular, check the Braces on the top tubes and
Brackets on the Glide Ride, as these can be damaged through improper use / or excessive lateral
movement.
Oil all metallic moving parts at least one time a month.
CAUTION
Do not allow children to use the swing set until the maintenance has been carried out. The
use of swing set not in first class condition exposes the child to the risk of injury. As a
parent, supervisor, owner or guardian, it is your responsibility to ensure that the swing
set is properly maintained. Spare parts are available through ACTION SPORTS
Customer Service centre. Please call 1800 465 070 (Australia) or 09 477 6020 (New
Zealand).
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:19

Swing Sets Limited Warranty
ACTION SPORTS warrants its swing set products to be free from defects in material and
workmanship under normal use and service conditions.
The various components of the swing set are warranted against defects and workmanship for
6 months.
All warranty coverage extends only to the original retail purchaser from the date of purchase.
ACTION SPORTS’obligation under this Warranty is limited to replacing or repairing, at
ACTION’s option, the product or parts therein. Any enquiries relating to warranties or spare
parts must be directed to our Freecall 1800 465 070 (Australia) or Standard call 09 477
6020 (New Zealand). For efficient processing of your enquiry please have relevant date of
purchase, retailer name you purchased the item from and the brand on the product. This
warranty does not extend to any damage to a product caused by abuse, improper or abnormal
usage (as detailed in this instruction manual), or repairs not provided byACTION. Nor does
this warranty extend to products used for commercial or rental purposes. This warranty does
not cover ordinary wear, tear and weathering, failure to follow directions, improper
installation, improper maintenance or acts of God (such as damage caused by storms,
lightning and by snow or ice). No other Warranty beyond that specifically set forth above is
authorised by ACTION.
Our sales and service centre has been set up to provide assembly assistance, replacement parts
and accessories, and to efficiently handle all warranty related matters.
Opening hours: 9am – 4:30pm Monday to Friday (excluding Public Holidays)
9am–3pmSaturday
www.actionsports.com.au
© ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page:20
Table of contents
Other Action Sports Play Set & Playground Equipment manuals
Popular Play Set & Playground Equipment manuals by other brands

Yard Craft
Yard Craft Pluto Assembly manual

Mercia Garden Products
Mercia Garden Products 02CHYTWR-V2 instructions

SMB
SMB Skyclimber technical information

Forpark Australia
Forpark Australia FREESTANDING SPRINGS AND ROCKERS installation manual

Quadro
Quadro YOUNGSTER Construction manual

BOERPLAY
BOERPLAY BBPE162.0BR installation instructions