
Care Instructions
CARE & MAINTENANCE
Your Solo table has been designed and produced to a high standard. With correct use
and maintenance it will give you many years of trouble-free service.
Please read the following instructions:
Regularly inspect the tilt mechanism and all screw fittings and lever handles to
ensure that they are in good working order.
Brakes, wheels and tyres are subject to wear. If they need to be replaced, the
work must be carried out according to the fitting instructions provided.
Only genuine parts should be used when your Solo table is repaired.
Regular lubrication of moving parts will extend the life of your Solo table and will
make adjusting parts easier. Use a spray lubricant and wipe off any excess
spray. Any overspray will encourage a build up of dirt.
Make sure that you are familiar with the adjustments on your Solo table. It
should always adjust easily, so do not force the mechanism if it does not move
easily. Stop and read the user guide again.
Wheels and other plastic or metal parts may be wiped clean with warm water and
a mild detergent.
Never clean the Solo table with abrasive cleaners, ammonia based, bleach
based or spirit based cleaners.
After exposure to damp conditions, dry off your Solo table with a soft cloth, and
leave with the Table top upright in a warm, dry environment.
Store your Solo table in a dry, safe place.