Active WizzyBug User manual

WizzyBug Joysck Center Mount
with
Oponal Lap-Tray
Active Healthcare Solutions ltd.
Unit 163 - 5489 Byrne Road
Burnaby, BC V5J 3J1, Canada
T: 1(888)712 – 2848; F: 1(888) 971-6966
E: info@acvehs.ca
_Ref.0.1

Assembling and Adjusng
Receiver inseron and horizontal adjustment
The WizzyBug Center Mount Joysck was created to allow for posioning of a Secondary Joysck in the
center line of the seat. It is a very versale addion to the WizzyBug. It allows for both forward and a
and vercal as well as le and right posioning of the Joysck.
The lap tray is generous in size and is well padded and secure. The padding is held in place with Velcro
and can be removed to allow for buons or a Moozi joysck to be installed on the tray.
Tools Needed for assembly
3/16” Allen Wrench
5/32” Allen Wrench
3/32 Allen Wrench
Remove the seat from the WizzyBug. Remove the small bolts to all the Reciever to slide
into the slot and insert the Receiver into the slot and insert it into the seat base.
Turn the seat upside down and aach the small screws using a 3/32” Allen wrench. There are 3 posions available:
20mm (3/4”) from the seat, 10mm (3/8”) from the seat and ght to the seat .
NOTE: It is best to slightly loosen the four larger bolts holding the socket in place rst then posion the receiver in
the seat holes and ghten the bolts. Once that is done reghten the larger bolts. Use a 5/32” Allen wrench.
3/32” allen wrench
5/32”
allen wrench
3 posion sengs:
20mm 10mm 0mm
Active Healthcare Solutions ltd.
Unit 163 - 5489 Byrne Road
Burnaby, BC V5J 3J1, Canada
T: 1(888)712 – 2848; F: 1(888) 971-6966
E: info@acvehs.ca
_Ref.0.1

Post and T-bar inseron and posioning
T-bar Posioning
The post and T-bar assembly slides into the receiver and has a 4” vercal height adjustment range.
The locking ring is used to secure the post in place once the desired height is set so that the assembly can be removed
and replaced at the same height. It also has a pin which helps keep the post and T-bar from rotang.
The post can be ghtened in the receiver using the clamp lever and the ring can be ghtened with a 3/16 allen wrench.
4”
Using a 5/32” allen wrench to loosen the clamp the T-bar can be rotated to move the T-bar closer to or further
away from the child. This allows for a possible adjustment range of 4.5 cm either way.
4.5 cm 4.5 cm
Loosen clamp here
Active Healthcare Solutions ltd.
Unit 163 - 5489 Byrne Road
Burnaby, BC V5J 3J1, Canada
T: 1(888)712 – 2848; F: 1(888) 971-6966
E: info@acvehs.ca
_Ref.0.1

Oponal secondary Joysck installaon and adjustment
The oponal Secondary Joysck is secured to the mount using two
bolts with a spacer. The clamp slides over the T-Bar and can be
posioned on the le or right side as needed. It is ghtened with a
3/16” allen wrench. The clamp allows the joysck to rotate so that
when the T-bar is rotated the joysck is able to stay level.
Pommel
The Pommel can be easily removed by loosen the locking screw on the front
with a 5/32 allen wrench.
Note that the Pommel must be installed before the post is inserted into the
Receiver.
Spacer
Bolts aach
to Joysck
The joysck can be placed on the posterior or anterior
side of the T-bar. It can also slide from side to side on
the T-bar and be locked in place where needed.
NOTE: where the joysck is reversed to put the sck so
the buons are away from the child the joysck must
be reprogrammed. A cover is available to prevent the
child playing with the buons.
Active Healthcare Solutions ltd.
Unit 163 - 5489 Byrne Road
Burnaby, BC V5J 3J1, Canada
T: 1(888)712 – 2848; F: 1(888) 971-6966
E: info@acvehs.ca
_Ref.0.1

The Oponal Lap Tray
Right and le side complete secons. Including removable
pads as well as adjustable side and rear safety bolsters
The Lap Tray secons slide on to the T-Bar
and are ghtened in place with a 3/16”
Allen wrench.
The pads are removeable allowing for the placing of buons or a Moozi Joysck
if that is the way the child controls the WizzyBug
Complete Lap Tray with the Secondary Joysck
Active Healthcare Solutions ltd.
Unit 163 - 5489 Byrne Road
Burnaby, BC V5J 3J1, Canada
T: 1(888)712 – 2848; F: 1(888) 971-6966
E: info@acvehs.ca
_Ref.0.1

AHS-WB-LTASS-01 Lap Tray
With removable pads and side and rear safety bolsters
AHS-WB-CM-01 Center Mount with:
• Receiver
• Post and T-bar
• Locking ring
• Joysck mount
AHS-WBPL-01 Pommel
Fully padded, slides and rotates on the post
Parts and Accessories
Code# Descripon
Active Healthcare Solutions ltd.
Unit 163 - 5489 Byrne Road
Burnaby, BC V5J 3J1, Canada
T: 1(888)712 – 2848; F: 1(888) 971-6966
E: info@acvehs.ca
_Ref.0.1

DX2-RJM DX Secondary remote Joysck
This is a SECONDARY remote Joysck in addion to a Master Remote “DX Joysck system,
DX Remote Display. This enables the user to have a wider choice of input or specialized rehab
controls. Standard proporonal or Low force joysck for mounng in a range of posions.
Mounng hardware included with the Center Mount Assembly.
DX2-RJM-LF DX Secondary remote Joysck Low Force**
DA-4BS 4 Buddy buons (red, blue, yellow, green)
For mounng on lap tray
DA-MOZ Moozi Assessment kit
Low prole switch joysck that oers an easy to use soluon for power chair control,
work with DA-ACC switch interface. Moozi comes in the following colors: red, blue or
black. Can be aached to Lap Tray.
Parts and Accessories
Code# Descripon
Active Healthcare Solutions ltd.
Unit 163 - 5489 Byrne Road
Burnaby, BC V5J 3J1, Canada
T: 1(888)712 – 2848; F: 1(888) 971-6966
E: info@acvehs.ca
_Ref.0.1