Acuity Brands sensorswitch SFR Series Installation manual

PLEASE READ ALL 4 STEPS BEFORE PROGRAMMING
1. Enteraspecicprogrammingfunctionbypressingbuttonthenumberoftimesas
the desired function number from the tables on the reverse (e.g., press twice for
function 2, Occupancy Time Delay).
2. The selected function’s current setting will then be read out in a sequence of LED
ashes(e.g.,veashesfor10min).Tochangesetting,proceedtostep3before
sequence repeats 3 times.
3. Whilethesensorisashingbackcurrentsetting,interruptitbypressingbuttonthe
number of times for the new desired setting as indicated in the particular function’s
detailedtable(e.g.,pressseventimesfor15min).Sensorwillbegintoashnew
settingasconrmation.
4. Once new setting has ashed back three times, sensor will exit programming
modeandLEDwillreverttoashingwhenoccupancyisdetected.
Note: To exit programming mode without saving or to change to a different function, wait
for blink back sequence to repeat 3 times then return to step 1.
DOC# IC1-002
Date Code 1611
OCCUPANCY SENSOR
PROGRAMMING INSTRUCTIONS
Technical Support: 1.800.727.7483

2 OCCUPANCY TIME DELAY
The length of time an occupancy sensor will keep the lights on after it last detects
occupancy (assuming Minimum On Time, if engaged, has been met).
4 100 HOUR BURN-IN / AUTO SET-POINT
TEST MODE
Disables Minimum On Time and sets Occupancy Time Delay to 30 sec.
Mode will expire after 10 min or if function 4 is set back to Normal.
100 HOUR BURN-IN
  Overrides relay on for rst 100 hrs of powered operation (typically for lamp
seasoning). LED blinks continuously while mode is enabled.
10 MINIMUM ON TIME
The length of time required for lamps to be on in order to prevent all short cycling
that shortens lamp life. If occupancy time delay expires prior to minimum on time
 beingsatised,thelampswillremainonuntiltimehasbeenmet.
FUNCTION DEFINITIONS ___________________________________
(*DEFAULT SETTING)
DETAILED FUNCTION TABLES _____________________________
2 = Time Delay
1 30 sec 4 7.5 min 715.0 min
22.5 min 5 10.0 min* 817.5 min
35.0 min 6 12.5 min 9 20.0 min
4= Test Mode / 100 hr Burn-In / Auto Set-Point
1Normal* 2Run 100 hr Burn-In 6Test Mode 1
1 Test Mode will disable Minimum On Time and set Occupancy Time Delay to 30 sec.
Mode will expire after 10 min or if function 4 is set back to Normal.
10 = Minimum On Time
10 min 3 30 min 5 60 min
215 min* 4 45 min