Adcraft WB-100 User manual

WB-100
Water Boiler
This manual contains important information regarding your
Admiral Craft unit. Please read this manual thoroughly prior to
equipment set-up, operation and maintenance. Failure to comply
with regular maintenance guidelines outlined in this manual may
void the warranty. MUST READ!!!

WARNINGS
Do not touch any hot surfaces
Do not use machine with wet hands.
Do not immerse unit, cord or plug in liquid at any time
Unplug cord from outlet when not in use and before cleaning.
Plug only into a 3-hole grounded electrical outlet
Do not operate unattended
Do not use this unit for anything other than intended use
Do not use outdoors
Keep children and animals away from unit
Always operate on a firm, dry and level surface at least 12” from walls or any other obstruction
Do not use unit with a damaged cord or plug, in the event the appliance malfunctions, or has been damaged in any
manner
Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to property loss and injury.
All repairs should be done by authorized professionals only
Ensure that the power supply you are using is adequate for continual usage and the voltage is correct.
The minimum volume to operate must be at least 1/3 of the maximum capacity.
The lid must be closed when operating unit.
TO USE
1. First, confirm the switch is off and the thermostat is set at “0” position.
2. Fill the urn to at least half of total capacity with cool water.
3. Place the lid on unit.
4. Plug the power cord into the appropriately rated outlet.
5. Turn the power switch “On”. The light will illuminate to indicate the power is connected.
6. Control desired temperature by turning the knob.
7. When the indicator lights up, the boil pressure is completed. Hot water is now ready to be served.
8. When the temperature cools down to about 10°C or (50°F), the unit will restart and heat up automatically and the
indicator will light up again.
9. When the temperature cools down to about 100°C or (212°F), the unit will maintain a boiling temperature until setting
is reduced.
CLEANING –NOTE: To maintain cleanliness and increase service life, the brewer should be cleaned every four
weeks. Do not immerse the unit in water or any other liquid. If liquid enters the electrical compartment it may cause a
short circuit or electrical shock.
*On areas of the heating element, hard water will cause chalk and limestone to accumulate over time. It is
recommended that you de-sediment when it is determined there are scale sediments at the bottom of the unit.
1. Before cleaning or attempting to move water boiler, unplug from outlet.
2. Pour 200ml of fresh lemon juice or concentrated lemon juice into the urn.
3. Wait 5 minutes to allow the lemon juice to penetrate.
4. A brush with soft bristles may be used to gently clean the unit.
5. Repeat steps 1-3 until all residue is removed.
6. Use a dry cloth to wipe away the lemon juice.
7. Rinse with clean water and brush the heating element lightly.
8. To avoid damage, do not use abrasive cleaners or scouring pads.
9. If soap or chemical cleaners are used, be sure they are completely rinsed away with clear water immediately
after cleaning. Chemical residue could damage or corrode the surfaces of the unit.

WB-100
VER811

1
2
3
4
5
6
7
8
9
10
12
13
14
15
16
18
17
19
20
21
22
23
24
25
26
WB-100
VER811

Water Boiler - WB-100
Reference
Number Part Number Description
1CP-01 Cover with knob
2WB-2 Plastic Handle
3Fixer of Urn's Shaft S/S
4CP-18 Screwcap for Sleeve
5Sealing of Graduation
6Fixer of Water Graduation
7CP1-11 Glass Graduation
8CP1-12 Sleeve for Graduation
9Screw of Glass Graduation
10 CP-13 Spigot
12 WB-12 Indicator Light - Clear
13 CP-17 Lighted Switch - Red
14 Base of Urn
15 WB-15 Foot
16 Terminal Block
17 Bottom Cover Support
18 CP-15 Power Cord and Plug
19 Base of Urn
20 WB-20 Thermos Cutoffs
21 WB-21 Thermostat
22 WB-22 Temperature Knob
23 WB-23 Adjustable Thermostat
24 WB-24 Heating Element
25 Heating Dish Gasket
26 Body of Urn
VER811

ACE Equipment One Year Limited Warranty
Admiral Craft Equipment Corp. (ACE) warrants its equipment against defects in materials and workmanship, subject
to the following conditions:
ACE Equipment is warranted for one year, effective from the date of purchase by the original owner. A copy of the
original receipt or other proof of purchase is required to obtain warranty coverage. This warranty applies to the original
owner only, and is not assignable.
Should any product fail to function in its intended manner under normal use within the limits defined in this
warranty, at ACE’s discretion, such product will be repaired, replaced with a refurbished unit, or replaced with a new
unit by ACE, after defective unit has been inspected and defect has been confirmed. ACE does not assume any liability
for extended delays in replacing any item beyond its control. This warranty does not apply to rubber and non-metallic
synthetic parts that may need to be replaced due to normal usage, wear or lack of preventative maintenance.
This warranty covers products shipped into the 48 contiguous United States, Hawaii, and metropolitan areas of Alaska
and Canada. Warranty coverage on products used outside the 48 contiguous United States, Hawaii and metropolitan
areas of Alaska and Canada may vary. Contact ACE for details at 1-800-223-7750
The following conditions are not covered by warranty:
• Equipment failure relating to improper installation, improper utility connection or supply and problems due to
improper ventilation.
• Equipment that has not properly been maintained, damage from improper cleaning, and water damage
to controls.
• Equipment that has not been used in an appropriate manner, or has been subject to misuse, neglect, abuse,
accident, alteration, negligence, damage during transit, delivery or installation, fire, flood, riot, or act of God.
• Equipment that has the model number or serial number removed or altered.
• Equipment on which the security seal has been broken.
If the equipment has been changed, altered, modified, or repaired without express written permission from ACE, then the
manufacturer shall not be liable for any damages to any person or to any property, which may result from the use of this
equipment thereafter.
This equipment is intended for commercial use only and this warranty is void if equipment is used in other than a
commercial application.
For warranty and non-warranty related issues please call ACE at 1-800-223-7750 ext 3 to speak to technical support.
When calling please have your model number, serial number and proof of purchase ready. To purchase replacement
parts, receive online technical support or fill out a warranty claim visit www.admiralcraftequipment.com. It is not
necessary to contact the place where you originally purchased your product from.
“THE FOREGOING WARRANTY IS IN LIEU OF ANY AND ALL WARRANTIES EXPRESSED OR IMPLIED
INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILTY OR FITNESS FOR PARTICULAR
PURPOSES AND CONSTITUES THE ENTIRE LIABILITY OF ACE. IN NO EVENT DOES THE LIMITED
WARRANTY EXTEND BEYOND THE TERMS STATED HEREIN.”
VER0112