Addonics Technologies ADIDECF User manual

Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: [phone]
Email: http://www.addonics.com/support/query/
v4.1.11
PCI Slot Mount
Bay Mount
40-Pin IDE Connector
4-Pin Floppy
Power Connector
Eject Button
Master/Slave Setting
CF/MD Slot
40-Pin IDE Connector
4-Pin Floppy
Power Connector
Eject Button
Master/Slave Setting
CF/MD Slot
T E C H N O L O G I E S
User Guide
IDE CF Adapter
(ADIDECF, ADIDECFB, ADIDECF-N)

Addonics IDE/CF Converter Board is a converter solution for the IDE port to have
CF card interface. It has a standard 40 pin or 44-pin IDE port, which can interface
to IDE host side and 50-pin Compact Flash socket in device side.
This is a convenient interface that allows Compact Flash modules to be used in
any system that has a standard IDE 40 pin or 44-pin connector.
Features
• 40 pin or 44 pin IDE standard Port
• Simple plug and play, no drivers required
• OS independent
• Support Compact Flash TM cards (Type I & II) or IBM Microdrive TM
• Transparent to the operating system and does not require any drivers
• The CF card can be the primary booting device containing the OS and
application
• Mount in PCI slot or 3.5” drive bay.
Software Installation:
Step 1
Connect Y-type power cable to this Bridge board and PC Power Supply (Ignore this
step when you use 44pin IDE connection which already have power input)
Step 2
Set jumper on IDE Master mode or Slave mode (J1 ON = Master, J1 OFF = Slave)
Step 3
Connect IDE connector to IDE host port or IDE flat cable
Important: IDE interface cannot support hot swap. When you insert or remove the
CF card, power off your system.
www.addonics.com
Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
CONTACT US