Advantech VEGA-320 Installation and operation manual

VEGA-320 Startup Manual 1
Before you start installing your card, please make sure that
the following items have been shipped:
1 x VEGA-320 card
1 x 1960091939T001 heatsink with thermal pad
1 x Edge AI Suite download card
1 x M.2 screw
1 x Start up manual
1 x China RoHS
If any of these items are missing or damaged, please con-
tact your distributor or sales representative immediately.
Product Pictures
Top View Bottom View
VEGA-320 Intel
TM
Movidius
TM
Myriad X Edge AI Module
Startup Manual
1. Remove the thermal pad protecting lm.
2. Check the installation direction as below, the top side of
the VEGA-320 has components which generate heat,
and should contact directly with the thermal pad.
3. Align the notch of the VEGA-320 to the clamp of
heatsink.
Heatsink Installation
Packing List
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
For technical support and service, please visit our
support website at:
http://support.advantech.com
This manual is for the VEGA-320.
Part No. 2046032000
Printed in China
1st Edition
July 2019

2 VEGA-320 Startup Manual
Heatsink Installation (Cont.)
4. Gently slip the edge with the notch down at 30o, until
the PCBA is held under the two clamps on the same
side.
5. Gently push the other side of the VEGA-320 down, until
the PCBA is held under all the four clamps evenly.
6. Secure VEGA-320 with the heatsink to the mainboard
M.2 2230 A/E Key slot using the screw in the box.