aebi schmidt meyer 66190 User manual

Meyer 66190 Spreader Controller
Transmitter LED Light Codes
Red LED Light
Blinks once per second Low Battery
Green LED Light
Binks once per second Transmitter on –not communicating with
the receiver
Blinks twice per second Transmitter on –Communicating with
the receiver
Solid Clutch is engaged
Charging Port
1
2
4
3
5
6
Transmitter
Receiver
Specifications
Battery 12 Volt Battery
Frequency 902-928-MHz FHSS 10Mw
Transmitter Battery Standard Micro USB wall or car port
Operation
1. Press and hold the POWER button for at least
three seconds to turn on the transmitter. The green
LED light will begin to blink.
2. Set engine throttle to choke by pressing and
holding the throttle INCREASE button for at least
three seonds.
3. Press and hold the engine START button until the
engine starts. NOTE: Continuing to hold the engine
button after the engine starts may result in engine
damage.
4. Once the engine starts, press the throttle
DECREASE button to remove throttle from choke
position.
5. Press the throttle INCREASE or throttle
DECREASE button until the desired engine RPM is
achieved.
6. Engage the electric clutch by pressing the
CONVEYOR button once. Pressing the
CONVEYOR button a second time will disengage
the clutch. NOTE: The green LED light will turn
solid whenever the clutch is engaged.
7. Engine can be stopped by pressing the engine
STOP or POWER buttons. NOTE: Pressing the
engine STOP or POWER buttons will automatically
disengage the electric clutch.
The control system consists of a transmitter and a
receiver. The receiver is mounted to the spreader
near the gasoline engine. The transmitter is
intended to remain in the vehicle cab or with the
operator.
Button Functions
1Power On/Off
2Engine Start
3Engine Stop
4Throttle Decrease
5Throttle Increase
6Conveyor On/Off
The wireless gasoline engine controller is intended to control the start/stop, throttle increase/decrease
and electric clutch on/off functions

Meyer Products
18513 Euclid Ave.
Cleveland, Ohio 44112
Phone: [phone]
www.meyerproducts.com
Scan for additional support
information.
Technical data is subjectto change.
Illustrations are not binding.
Each transmitter and receiver pair are
synchronized at the factory. If a new
transmitter is needed, use the following
procedure to synchronize:
Make sure both the transmitter and receiver
are powered off.
Press and hold the POWER button on the
transmitter for at least 10 seconds. Both the
red and green LED lights will begin to blink.
Apply power to the receiver. Wait for a few
seconds until only the green LED light begins
to blink. The transmitter and receiver are now
synchronized.
Synchronizing Transmitter and Receiver
Sleep Time Adjustment
The sleep mode will automatically shut off the
transmitter, disengage the electric clutch and
stop the gasoline engine. The transmitter is
factory set to go into sleep mode after 15
minutes of inactivity. Use the following
procedure to change the sleep time or disable
sleep mode:
With the transmitter powered off, press and hold
the POWER button, throttle DECREASE, throttle
INCREASE and CONVEYOR buttons.
Release the buttons. The red and green LED
lights will blink once per second.
On the transmitter press one of the following
buttons for desired sleep time:
▫ENGINE STOP –15 Minutes (default setting)
▫ENGINE START –30 Minutes
▫THROTTLE INCREASE – 1 Hour
▫THROTTLE DECREASE – 2 Hours
▫CONVEYOR –Disable Sleep Mode
www.aebi-schmidt.com
©Aebi Schmidt Group, 2023