10 Rev 0.0
USER INSTRUCTIONS
EN
Only run a soak program with half loads.
After using the above table to choose the most suitable washing cycle, program
the appliance.
Before starting a washing program, make sure that:
The water supply tap is• open.
There is regenerating salt• in the water softener tank (to add salt,
see the instructions in the general manual).
The correct amount of detergent• has been added to the dispens-
er (to add detergent, see the instructions in the general manual).
The spray arms are able to rotate• freely and without obstruction.
The racks have been• correctly loaded (see the instructions in the
general manual).
The dishwasher door• is securely closed.
2.2.1 Switching on
Press on/o (ref. 1 g. 2-02) to start the dishwasher; the indicator lights show the
“status”of the dishwasher.
2.2.2 Selecting and starting the program
Programming operations can only be performed with the door closed.
With the door open, the program indicator lights (ref. 4 g. 2-02) remain
o.
Press the program• selection button (ref. 3 g. 2-02) several times until the indi-
cator light corresponding to the required program turns on (ref. 4 g. 2-02);
if necessary, press the relative buttons to select the complementary functions•
you wish to use (e.g.“Programming delay”);
to start the dishwasher, press the• start/pause button (ref. 2 g. 2-02) for a few
seconds until the indicator light of the selected program starts ashing (con-
rmation beep);
Program status is indicated by the indicator light ashing throughout the•
cycle.
If the door of the dishwasher has not been closed or has been incorrectly
closed, the washing cycle will not begin.