AEG IDK84454IB Technical manual

IDK84454IB
EN Instruction on mounting and use

EN - Safety and Regulations
Strictly observe the instructions in
this manual. All liability is declined for
any problems, damage or fires caused by
failure to comply with the instructions in
this manual. The device is intended for
domestic use only, to cook food and
extract the fumes generated by cooking.
No other use is allowed (e.g. heating
rooms). The manufacturer declines any
liability for inappropriate use or incorrect
control settings.
The device may have different aesthetic features with
respect to the illustrations in this handbook, however
the operating, maintenance and installation
instructions remain the same.
Read the instructions carefully: they include important
information about installation, use and safety.
Do not make electrical changes to the device.
Before installing the device, make sure that none of the
components are damaged. Otherwise, contact the dealer
and do not continue with the installation.
Check that the device is intact before continuing with
installation. Otherwise, contact the dealer and do not
continue with the installation.
Note: The parts marked with the symbol "(*)" are optional
accessories supplied only with some models or otherwise not
supplied, but available for purchase.
1. Warnings
Please note! Pay strict attention to the
following instructions: ● The device must
be disconnected from the electric power
supply before carrying out any installation
work. ● Installation or maintenance must
be performed by a qualified technician, in
compliance with the manufacturer’s
instructions and local safety regulations.
Do not repair or replace any part of the
device unless specifically stated in the
operating manual. ● By law, the
appliance must be earthed. ● The power
cable must be long enough to allow the
device built into the unit to be connected
to the power supply. ● In order for the
installation to comply with current safety
regulations, an approved omnipolar
circuit breaker is required that
guarantees complete disconnection of
the mains in overvoltage category III, in
accordance with the installation rules. ●
Do not use power strips or extension
cords. ● Once installation is complete,
the electrical components must no longer
be accessible by the user. ● The device
and its accessible parts get hot during
use. Be careful not to touch the heating
elements. ● Ensure that children do not
play with the device; keep children away
and supervise them because the
accessible parts may become very hot
during use. ● For people with
pacemakers and active implants, it is
important to check, prior to using the
induction hob, that their pacemaker is
compatible with the device. ● Do not
touch the heating elements of the device
during and after use. ● Avoid contact
with cloths or any other flammable
material until all the hob components
have cooled down sufficiently, risk of fire
● Do not place flammable material on or
near the device. ● Overheated fats and
oils easily catch fire. Supervise the
cooking of fatty or oily food. ● If the
surface is cracked, switch the device off
immediately to prevent the risk of an
electric shock. ● The device is not
intended to be operated with an external
timer or a separate remote control
system. ● Unattended cooking on a
device with oil or fat can be dangerous
and may cause a fire. ● The cooking
process must be supervised. A short
cooking process must be constantly
monitored. ● NEVER attempt to put fires
out using water. Instead, turn off the
device and smother the flames, for
example with a lid or a fire blanket. Fire
hazard: do not place objects on the
cooking surfaces. ● Do not use steam
cleaners, risk of electric shock. ● Do not
place metal objects, such as knives,

3
forks, spoons or lids on the device
because they could become hot. ●
Before connecting the device to the
electrical network: check the data plate
(on the bottom of the device) to ensure
that the voltage and power correspond to
the mains supply and that the power
socket is suitable. If in doubt, consult a
qualified electrician.
Important: ● After use, turn off the hob
at the switch and do not rely on the pan
detector. ● Prevent liquids from boiling
over, so turn the heat down when boiling
or heating liquids. ● Do not leave the
heating elements turned on with empty
pots and pans or with no pans. ● Switch
off the relevant hot plate when you have
finished cooking. ● Never use aluminium
foil for cooking and never place products
packaged in aluminium on the hob. The
aluminium would melt and irreparably
damage your device. ● Never heat a tin
or can containing foods without opening it
first: it might explode! ● This warning
also applies to all other types of hobs. ●
High power levels such as the Booster
function should not be used to heat
certain liquids, such as oil for frying.
Excessive heat may be dangerous. In
these cases, we recommend the use of a
lower power level. ● Containers must be
placed directly on the hob and in the
centre. Under no circumstances may any
other objects be placed between the pan
and the hob. ● If the temperature
becomes high, the device automatically
decreases the power level of the cooking
zones. ● Before doing any cleaning or
maintenance work, disconnect the device
from the mains power supply by
removing the plug or turning off the
mains switch. Wear protective gloves for
all installation and maintenance
operations. The device can be used by
children over the age of eight and by
people with impaired physical, sensory or
mental abilities or lacking in experience
or the necessary knowledge provided
that they are supervised or after they
have received instruction about how to
safely use the device and understand the
inherent dangers. Children must be
supervised to ensure they do not play
with the device. Cleaning and
maintenance must never be performed
by children unless they are properly
supervised. The room must be properly
ventilated when the device is used at the
same time as other gas-powered
devices, or powered by other fuel. The
device must be regularly cleaned both
internally and externally (AT LEAST
ONCE A MONTH), in strict accordance
with the maintenance instructions. Failure
to follow the rules for device cleaning and
filter replacement and cleaning may
result in a fire hazard. Food must never
be cooked flambè. Using a naked flame
may damage the filters and cause a fire
hazard; it must, therefore, be avoided
under all circumstances. Extra care must
be taken when frying to prevent the oil
from overheating and catching fire. ●
PLEASE NOTE: The accessible parts of
the device may become hot when the
hob is switched on. ● Please note! Do
not connect the device to the electric
power supply until installation has been
fully completed. The regulations laid
down by local authorities must be strictly
followed with regard to the technical and
safety measures to adopt for fume
extraction. ● The extracted air must not
be conveyed through the same ducts
used to extract the fumes generated by
gas combustion or other types of
combustion devices. Never use the
device without the grille properly
installed! Only use the fastening screws
supplied with the device for installation,
or if not supplied, purchase the correct
type of screws. Use screws of the right

4
length, as indicated in the installation
guide. ● When the device is used
together with other devices powered with
non-electrical energy, the negative
pressure of the room must not exceed 4
Pa (4 x 10●5 bar). This manual must be
stored for future consultation at any time.
If sold, transferred or moved, it must
remain with the device.
This device is marked in compliance with the European
Directive 2012/19/EC, Waste Electrical and Electronic
Equipment (WEEE). By ensuring that this device is disposed
of correctly, the user will help prevent potential negative
impacts on the environment and human health.
The symbol on the device or documentation provided
indicates that this device must not be treated as domestic
waste, but must be taken to a suitable waste collection site for
the recycling of electrical and electronic appliances. Dispose
of it in accordance with local regulations for waste disposal.
For further information about the treatment, recovery and
recycling of this device, please contact your local authority,
the collection service for household waste or the shop from
where the device was purchased.
Device designed, tested and developed in compliance with
regulations on:
• Safety: EN/IEC 60335-1; EN/IEC 60335-2-6, EN/IEC 60335-
2-31, EN/IEC 62233.
• Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO
5168; EN/IEC 60704-1; EN/IEC 60704-2-13; EN/IEC 60704-3;
ISO 3741; EN 50564; IEC 62301.EN 60350-2;
• EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2;
EN/IEC 61000-3-3; EN/IEC 61000-3-12. Recommendations
for correct use in order to reduce the impact on the
environment: When you start cooking, turn the device on at
minimum speed, leaving it on for a few minutes when you
have finished cooking. Increase the speed only if there is a
large quantity of fumes and steam, using the Booster function
only in extreme cases. To keep the odour reduction system
running efficiently, replace the carbon filter/s when necessary.
To ensure the high performance of the grease filter, clean it
when necessary. To improve efficiency and minimise noise,
use the maximum duct diameter indicated in this manual.
For Australia only:
The device is compliant to AS/NZS 60335.2.31 and AS/NZS
60335.2.6 .

1x
1x
1x
1x
2x
1x
1x
1x
1x
1x
2,8 m
4x
8x 4x 4x
1x
4x
2x 3,5x9,5mm
Source locally

min.50
min.500
min.40
min.40
1
Eu Market ONLY.
Do not remove adhesive label and
wires below.

1a
830
515
211
211
> 50
> 50
490
805
inst.A
P
P
20 - 60mm

50 >
805
834
519 490
r 12
1b
830
515
211
211
inst.B
s
s
6.5 mm
P
P
25 - 60mm
50 >
Source locally

1c
16
FRONT

2
.a
.b
.b

2a
1 x
2,8 m
inst.A

2b
1 x
2,8 m
inst.B

.a - see Chapter 3.1
3
OK!
OK!
.b
.a
.c
220V-240V ~
50Hz/60Hz
OPTIONAL
CONNECTION
2x
1 2 3
L
220V
240V
4
N
220V-240V ~
50Hz/60Hz
1x
380V-415V ~ 2N~
50Hz/60Hz
380V-415V ~ 3N~
50Hz/60Hz

.b
.c
N
L1
L2
380V-415V ~ 2N~
50Hz/60Hz
220V
240V
BROWN
BLACK
GREY
Y/G
BLUE
220V
240V
N
L1
L2
L3
380V-415V ~ 3N~
50Hz/60Hz
220V
240V
220V
240V
BROWN
BLACK
GREY
Y/G
BLUE
220V
240V

5
4
4x
OK!

6
x4
x4
x8
inst.B

7

7a.1
7a.2 7a.3
7a.4
BACK
FRONT
.a
.b
1
.a
.a
.b
ee