START THE APPLIANCE
1Open the water tap.
2Connect the mains plug to the mains socket.
3Press On/Off button to activate the appliance.
ALWAYS ACTIVATE THE APPLIANCE BEFORE LOADING
THE LAUNDRY INTO THE DRUM.
4Turn the programme knob to set a programme. The programme
indicator goes on.
5The display shows the default temeprature, maximum spin speed
and the empty indicator bar of the available functions. To change
the default values or to set functions press the corresponding
buttons.
6If necessary, set the delay start function.
7Put the laundry in the drum, one item at a time.
8The weight sensor shows the maximum load available ( ) and
your laundry load ( ). The weight of the laundry updates by step
of 0.5 kg.
9Do not overload the appliance.
10 Close the door.
11 The text bar on the display (A) tells the percentage of detergent to
use. To have PERFECT washing results with MINIMUM energy and
water consumption follow this suggestion.
12 Put the detergent and additives in the correct compartment of the
dispenser.
13 Press Start/Pause button to start the programme.
14 At the end of the programme the display shows a zero and the
message tells that the washing programme is completed. If you set
the Rinse Hold function refer to “At the end of the programme”
chapter in the user manual.
Daily Use with weight sensor
LANGUAGE SETTING
The first time you activate the appliance, the display shows the default
language and tells you to confirm it or change it:
1Turn the programme knob to set the desired language.
2When the display shows the necessary language, press Start/Pause
button to confirm the selection.
To change the language of the display AFTER first activation:
1Press Spin and Options buttons at the same time for some
seconds to activate the language set mode.
2Do again the previous 2 steps to set the new language.
CLOCK SETTING
After you set the language, the display tells to set the clock:
1The hour digits flash.
2Turn the programme knob to change the hour.
3Press Start/Pause button to confirm the selection.
4The minute digits flash.
5Turn the programme knob to change the minutes.
6Press Start/Pause button to confirm the selection.
To change the clock of the display AFTER first activation:
1Press Extra Rinse and Time Save buttons at the same time for
some seconds to acitvate the clock set mode.
2Do again the previous 6 steps to set the new time.
Before First Use