Aero Microaces Fokker Dr.1 Triplane User manual

Fokker Dr.1 Assembly Guide
Stage 1 - Airframe
Attach P1 & P2 to either side of D1 along the lower edge of the part. This can be done while D1
is still attached to the parts sprue. Attach P3 to D9 and P4 to D16 whilst also on the sprue.
Remove D1 from sprue and slot and glue formers D4 and D5 in positions shown above.
Attach D2 to the front of D1 and add triangular fillets D3 for reinforcement.
Remove material from D10 using the laser etched marks on the front face of the part.
Attach W1 to the front of D10 and secure one of the 4mm x 1 mm neodymium magnets into the
hole provided.
Attach D8 and D9 to D7 as shown above. Add stickers S1 and S2 to D4 and D11 respectively.
Fokker Dr.1 Assembly Guide