Aero Mist Portable Misting Tower 52430 User manual

InstallatIon InstructIons
Limited Warranty
Aero Mist, Inc. shall warrant the components of the Portable Mist Tower to be
free of defects in workmanship for 3 years. Maintenance items are not war-
rantable including nozzles and filters. No warranty of merchantability or other
warranty, expressed or implied, is made.
Liability for, and the exclusive remedy for, defective materials or workmanship,
is limited to the replacement or repair of defective products. This warranty ap-
plies only to the original purchaser of the Portable Mist Tower and is not trans-
ferable. Any parts found to be defective will be replaced at no charge. All parts
must be returned to Aero Mist, Inc. freight pre-paid by customer, and will be
returned to customer by Aero Mist, Inc., freight collect.
This warranty specifically excludes the following: Failure of parts due to dam-
age by accident, fire, freezing, chemicals, or unusual characteristics of water
supply, such as mineral and calcium buildup.
This warranty covers parts only. Any costs incurred due to replacement or repair
is the responsibility of the buyer and not covered under warranty.
23610 N 20th Dr, Ste 6, Phoenix, AZ 85085
[phone]
www.aeromist.com
P Or ta BLe
miStinG
tOWer
mOdeL 52430PATENT PENDING

LiSt Of aLL encLOSed PartS
QtY Part # DEscrIPtIon
1 1 Main Tubing Assembly
1 2 Star Lower Half
3 3 Leg Tubing
3 4 1/4 - 20 x 1 1/2” Bolt
3 5 1/4 - 20 Nut
1 6 Spray Bar
5 7 .014 Misting Nozzle
1 8 Compression Nut
1 9 Ball Valve
1 10 Upper Boot
tOOLS required
Phillips Screwdriver
5/8" Open-End or Adjustable Wrench
3/4" Open-End Wrench
1. Remove contents from box.
2. Insert Leg Tubing (#3) between upper and Lower Star (#2). Secure together with
Phillips Head Bolt (#4) and 1/4-20 Nut (#5). Leave the bolts loose at this time so the
other legs can be inserted. Once all leg tubes are secured, and then tighten bolts with
Phillips head screwdriver.
3. Insert Stainless Steel Spray Bar (#6) into Ball Valve (#9), Tighten Compression
Nut (#8) with 5/8”open end wrench. Use a 3/4” open end wrench on Ball Valve (#9) as
back up wrench. Secure Upper Boot (#10) over Ball Valve (# 9).
4. Hook up garden hose and flush for 20 seconds. Shut water off using Ball Valve located on
upper pole.
5. Install (5) .014 Misting Nozzles (#7) into threaded hole on Spray Bar (hand tighten only).
You are now ready to enjoy your Portable Misting Tower.
6. Twist upper pole counterclockwise to raise or lower for desired height.
maintenance
• Clean or replace nozzles as needed.
• Keep garden hose screen clean.
CAUTION! Misting system is intended for outdoor use only.
• Use potable water/fresh water only.
• Shut off garden hose when not in use
inStaLLatiOn inStructiOnS
OPtiOnaL acceSSOrieS
Part # DEscrIPtIon
52505 Inline Sediment Filter
52014 .014 Misting Nozzle
26105 Hose Y Valve
Please visit www.aeromist.com for additional parts and accessories.