Aero 31201.030 User manual

Installation instructions
LED UNDERWATER LIGHTING INSTALLATION INSTRUCTIONS
Please read the instruction carefully before installation.
Low voltage single color fitting:use external power supply,the input voltage of power supply must be
consistent with the requested input voltage of the fitting,as the fitting is constant voltage input type.
The power consumption of power supply must be decided by installer according to the requirements from
the site.
Example of wiring:
100-240V
Power(DC24V)
2-1.Fasten the nut with the screw by using
a tool.
1-1.Put the wave tube through the nut and the
rubber plug.
#The wave tube should reach the bottom of
the rubber plug#
6-1.Put the mounting sleeve into the holes .
6-2. Fasten it with the wall of the pool by a
screwdriver .
5-1.Fix the two type“L”bracket on the
mounting sleeve.
5-2.Dig a hole for the installation for each of
the mounting sleeve.
#The distance between these holes and
the ground should less than 1m.#
7-2.Turn on the power to make sure it is working .
7-3. Fix the light with the mounting sleeve by a
screwdriver.
7-1.Connect the lighting fixture with the power
cable by the connector .
#fasten the connector tightly to make sure
it can reach IP68.#
8-1.Pour the water into the pool after the
installation.
3-1.Put the cable through the wave
tube and the hole of the mounting
sleeve from outside .
3-2.Then insert the cable into the nut/rubber
plug and the screw of the PG13.5.
3-3.Fix the nut with screw of the PG13.5 tightly.
4-1.Screw the PG13.5 with the connector on
the wave tube tightly with two wrenches.
4-2.Fix the backcover to the mounting sleeve
by four screw.
165mm
<1m
>165m m
<1m

Explanations:the transmiss circuit of the whole group depends on the circuit of junction boxes. the max.
current depends on the max. load of power cable between the j unction boxer,but it is not related to t he
max. load current of power cable of the fitting.The outer dia meter of cable between the junction bo xes
is limited by the max. outer diameter of speedy plug,the max . allowed outer diameter is 10m m.
24VDC:circuit of product
The installation instructions apply to the following models
Item No. 31201.030
Constant voltage
LED driver
24VDC
100-240Vac
LED LED LED LED
LED UNDERWATER LIGHTING INSTALLATION INSTRUCTIONS
Please read the instruction carefully before installation.