BALL CHAIR
USER GUIDE #75061
SAFETY
Not all exercises are suitable for everyone. To reduce the risk of
injury, consult your physician before starting any exercise program
with this product or any other exercise equipment. Please ensure
that you do NOT have any medical or health conditions that could
affect the safety or effectiveness of your exercise program. If you
suffer from heart disease, high blood pressure, or any other health
conditions, consult your physician before starting any exercise
program. If at any time during your exercise you are experiencing
discomfort or pain, stop the exercise immediately and consult your
physician. The instruction presented herein is in no way intended as a
substitute for medical counseling. Perform stretches and exercises in
a slow and controlled manner. Stop and rest if you feel dizzy or short
of breath.
Choose a generously sized area that is clear of furniture and other
obstructions before performing stretches or exercises. Use the
product only on smooth surfaces. Do not use balls if deep scratches
or gouges are present. Use product only as intended. Please note
that the ambient temperature and pressure will affect the ball size.
Slight leakage is normal. Please adjust the inflation level as needed.
Lock casters firmly before performing stretches or exercises
when using the chair
CAUTION: Weight on this product should NOT exceed 300 lbs.
Ball may not inflate to 100% to size on initial inflation.
WAIT 24 HOURS. Deflate 50% and inflate again.
Due to the ball's material, the ball will increase to proper size
with second Inflation.
Please read before using or setting up the Aeromat® Ball Chair
CARE
1. Avoid exposing the ball to rough, sharp abrasive surfaces, heat
and excessive sunlight.
2. Avoid placing or rolling ball on newspaper or other materials
printed in ink as ink may permanently mark the ball.
3. Hand wash ball with a soft cloth and warm soapy water. Do not
use harsh or abrasive chemicals or cleaning tools that may scratch
the ball. Wipe chair with a damp cloth.
4. When using the ball chair, ensure all parts are firmly attached
with the ball pumped to recommended size of 49 cm in
circumference or to desired firmness. Leakage may occur over
time. Re-inflate when necessary.
BALL INFLATION
1.Remove the Aeromat® Ball Chair from the package and inspect for
any shipping damages. Follow Ball Chair assembly instructions.
Please note: It is normal for the ball to have slight creases when first
inflated. Make sure that the ball is at room temperature before
inflating.
2. Use the hand pump to inflate the ball. DO NOT overinflate.
3. Remove the hand pump and immediately insert the plug into hole.
*The ball is made of bust resistant material.
