Aethra Adsl71-2plus User manual

OVERVIEW

The module ADSL71-2plus must be combined with the Aethra®xDSL multi-

interface tester D2071.

It covers completely the ADSL technology, both ADSL over POTS and

ADSL over ISDN as well as new ADSL 2/2+.

Aethra supplies this card with all the variations to ADSL like G.DMT, G.Lite,

Full Rate, Multimode, etc. in order to be ready to face evey kind of link

during an installation or troubleshooting of a line.

Through the connection test, the ADSL link can be analyzed in depth,

thanks to parameters characterizing the line like Fast/Interleaved bit rate,

Noise Margin, Attenuation and many others.

The SMART STATUSTM feature allows the user, through the pression of a

single button, to display the DMT bit per tone in graphical and table format;

this is useful to investigate the portions of frequency spectrum negatively

influenced by crosstalk or any other noise.

The user can perform both high impedance and “during simulation” moni-

toring; then, all data captured can be analyzed either directly at customer

premise (through the powerful onboard decoding) or by using PC108 for

WindowsTM software.

For what concerns the ATM stack, the implementation of the OAM cells is

provided while AAL-5 is the ATM Adaptation Layer chosen for the packets

generation test. On this subject, pages dealing with errors and statistics are

available in order to allow a detailed analysis of the ATM layer.

The IP layer can be managed through the IP Ping test and the IP Generate

Traffic. While the former checks the connection to the Internet Provider, the

reachability of a remote host, the Trace Route and the response times, the

latter allows the simulation of a data transfer between two hosts. Further

tests are available to measure the throughput of the connection in

progress using high level HTTP and FTP protocols.

There are two operating modes: the ATU-R one simulates the user’s side;

the Through mode (Bridge) one carries out a simulation of the user’s

modem: this is achieved by placing the module and the main unit D2071

between the host and the CO side.

ADSL 1/2/2+ CARD FOR xDSL TESTER D2071

FEATURES AT A GLANCE

Support for all variations to ADSL 1/2/2+

(Annex A and B)

Background monitor during test execution

Full test set for IP Layer

Specific ATM layer tests

Light weight and easy portability

DMT bit per tone analysis for further spectrum

investigation

ATU-R mode and transparent mode

Modular philosophy

All you need for measurements dealing with

ADSL 1/2/2+

In-depth investigation

High impedance and “during simulation”

monitoring

“Live” status of the line

The status of the link with just a single button

pression,

ADSL71-2PLUS MODULE

IP [IP2071 OPTION]

•Multiplexing methods LLC/SNAP or VC multiplexed

•Data encapsulation methods IP over ATM Bridged (IPoA),

IP over ATM Routed (IPoE),

PPP over ATM,

PPP over Ethernet

•Authentication protocol PPP PAP, CHAP (MD5), none

•Type of Test IP Ping, IP Generate Traffic

(TFTP, ICMP), IP Trace Routing,

Web downloading (HTTP3),

Internet performances (FTP3)

•Address mode Static, Dynamic (DHCP)

•DNS Static, Dynamic discovery

OPERATING MODES

•ATU-R

•Through mode (Bridge) (option1)

•Host (main unit) (option1)

CONNECTORS

•ADSL 1/2/2+ 2 wires RJ11

•Main unit 68 wires Aethra Legacy

•Ethernet (main unit) 4 wires RJ45

standard 10/100BASE-T port

ENVIRONMENTAL CHARACTERISTICS

•Dimension

Weight

≈

65 gr.

Dimensions(mm) 54 (w) x 118 (l) x 33 (d)

•Power Power supply from the main unit

•Temperature

Storage/Transport -40oC to +70 oC

Operating, nominal -5oC to +45 oC

Operating, limits -10oC to +55 oC

•Humidity, non-condensing ≤93% RH @ 40 oC

≤70% RH @ 55 oC

•User's Safety Aspects EN 61010-1, EN 60950, EN 41003

•EMC Aspects EN 55022, EN 55024,

EN 61000-3-2 / -3-3

OPTIONS

•1ETH2071 Through mode (Bridge) adapter

•2IP2071 ATM and IP Suite Tests,

Statistics

•3INET71 Internet HTTP and FTP protocols

•PC108 Software PC108 for WindowsTM

4 Supported with ADSL71-2plus full option

TELECOM INTERFACES

•ADSL access

ATU-R ITU-T (CCITT) Rec. ITU-T-I.361,

ITU-T-I.363.5, ITU-T-I.432,

ITU-T-I.610, ITU-T-I.731

Chipset Conexant Systems, Inc.

ADSL LAYER

Full Rate4ANSI T1.413 issue 2

G.DMT4G.992.1, Annex A (ADSL over POTS)

G.992.1, Annex B (ADSL over ISDN)

G.Lite4G.992.2

Others4U-R2 (T-DSL),

Alcatel ETSI DTS/TM

ADSL2 G.992.3

ADSL2+ G.992.5 (Annex A, B, L, M)

•Handshake G.994.1 (ex G.Hs)

SMART STATUSTM

•Line voltage

•G826 ES, SES, BBER, UAS

•ADSL 1/2/2+ Near/Far LOS, LOF, LOP, LOM,

Loss of Sync, DMT bits per tone

•ATM link (option2)Near/Far HEC, CRC,

FEC counters,

Tx/Rx cells counters,

AIS-RDI-LB OAM cells counter,

Unmapped cells VCs (VCI/VPI),

Response Time, Last second and

Maximum ATM throughput rate

•AAL-5 link (option2)CRC and length counters,

Tx/Rx packets counters,

Last second frame and throughput,

Number of Tx/Rx bytes,

Maximum PDU throughput rate

•Ethernet link (option1)CRC counters,

Tx/Rx frames counters,

Last second frame and throughput,

Number of Tx/Rx bytes,

Maximum throughput rate

ATM [IP2071 OPTION]

•Cell Management F4, F5 OAM cell ITU-T I.610

•VCI/VPI User defined

•ATM Adaptation Layer AAL-5

•Type of Test Ping, packets test, Traffic Generator

TECHNICAL SPECIFICATIONS

AETHRA®SpA

via Matteo Ricci, 10

60126 Ancona (Italy)

Tel. +39.071.218981

Fax +39.071.887077

Video 1 +39.071.2189704

Video 2 +39.071.2189701

Pechino Hong Kong Londra Madrid

Città del Messico Miami Parigi San Paolo

Shanghai Shenzhen

Email:[email protected]

www.aethra.com

Aethra, the Aethra logo and ADSL71-2plus are registered trademarks of Aethra SpA in Italy and in other Countries. All other company and product names may be registered trademarks or trademarks of their

respective owners. All information provided by Aethra SpA in this datasheet is believed to be accurate. Aethra SpA reserves the right to discontinue and change specifications and prices at any time without notice.