65
WHAT TO DO...
1. When out of operating for a long time:
Remove the power supply ord.
Dry your refrigerator opening the door for 2-3 days.
2. When you get ready to move:
Se urely fasten removable interior parts (or move and pa kage them separately)
Do not lay your refrigerator horizontally, or ompressor may be damaged.
When you need service: Before you call for service make sure
you need it, check a few things noted below for yourself first.
If refrigerator is not operating:
Is the power supply ord unplugged?
Is home fuse blown or ir uit breaker off?
If refrigerator is warmer than usual:
Has the door been open frequently or for a long period?
Is refrigerator over rowded-preventing good air ir ulation?
Is the hot thing stored without ooling?
Is the learan e between refrigerator’s side and the wall allowed suffi iently?
If there are unusual sounds:
Is refrigerator pla ed on the level?
Are foreign obje ts behind the refrigerator?
Are dishes on refrigerator shelves vibrating?
If so, rearrange the dishes.
If the supply ord is damaged, it must be repla ed by the manufa turer or its
servi e agent or a simmilary qualified person in order to avoid a hazard.
CHANGING THE REVERSIBLE DOOR
Only AFR-501(BF.F)
This refrigerator has been built with the door hinges on the right.
If you wish to hange the opening dire tion, follow the instru tion below:
• Unplug the refrigerator from its ele tri al outlet.
• Empty everything in the refrigerator, in luding shelves, food, et .
1. Remove the hinge over on the right top
of the abinet.
2. Remove the two s rews (using a rat het
tool with a 8MM so ket) that hold the top
hinge to the abinet. Keep these s rews
for later use.
3. Lift the top hinge straight up to free the pin
from the so ket on the top of the door.
4. Lift the door and pla e it on a padded
surfa e to prevent s rat hing it.
5. Remove the plug buttons from the upper
left holes as illustrated and transfer them
to the un overed holes at the right side.
Be sure to press the plug buttons firmly
into the holes.
6. Lay the abinet on its side down on the
floor. Remove the two s rews that hold
the bottom hinge to the abinet using a
10MM so ket. Keep these s rews and
washer for later use.
