Aim EcuMaster EMU Black User manual

AiM User Guide
EcuMaster EMU Classic/
EMU Black – RS232
Release 1.01

1
1
Supported models
This user guide explains how to connect EcuMaster ECU to AiM devices. Supported model is:
•EcuMaster EMU Classic
•EcuMaster EMU Black
2
Software setup
Both EMU Classic and EMU Black ECU need a software setup to correctly communicate with AiM
devices via RS232. For both ECUs, you need to set "AiM Dashboard" device as shown here below.

2
3
Wiring connection
Below, the connectors pinouts are represented for both EMU Classic and EMU Black
3.1
EMU Classic
EMU Classic ECU features serial communication protocol on EMU extension port (ECU rear side) whose
pinout is shown below with the connection table.
Please note: with serial communication protocol it is mandatory to connect ECU GND with AiM device
GND as well as ECU TXD is to be connected to AiM ECU RS232 TX (or AiM RS232RX for older products)
and vice versa.

3
3.2
EMU Black
EMU Black ECU, as well, features serial communication protocol on EMU Black front connectors whose
pinout is shown below:
RS232TX: pin 11; 39 pins connector (Black)
RS232RX: pin 24; 39 pins connector (Black)
Please note: with serial communication protocol it is mandatory to connect ECU GND with AiM device
GND as well as ECU TXD is to be connected to AiM ECU RS232 TX (or AiM RS232RX for older products)
and vice versa.

4
4
AiM device configuration
Before connecting the ECU to AiM device set it up using AiM Race Studio software. The parameters to
select in the device configuration are:
•ECU manufacturer “AIM”
•ECU Model “PROT_UART”
5
Available channels
Channels received by AiM devices connected to “AIM” "PROT_UART" protocol are:
ID CHANNEL NAME FUNCTION
ECU_1 AIM_RPM RPM
ECU_2 AIM_WHEELSPD Wheel Speed
ECU_3 AIM_OILPRESS Oil pressure
ECU_4 AIM_OILTEMP Oil temperature
ECU_5 AIM_WATERTEMP Engine coolant temperature
ECU_6 AIM_FUELPRESS Fuel pressure
ECU_7 AIM_BATTVOLT Battery supply
ECU_8 AIM_THROTANG Throttle angle
ECU_9 AIM_MANIFPRESS Manifold air pressure
ECU_10 AIM_AIRCHARGETEMP Intake air temperature
ECU_11 AIM_EXHTEMP Exhaust gas temperature
ECU_12 AIM_LAMBDA Lambda value
ECU_13 AIM_FUELTEMP Fuel temperature
ECU_14 AIM_GEAR Engaged gear
ECU_15 AIM_ERRORFLAG Error flag