Aircare AURORA User manual

Everything you need to know about your
Read and save these instructions
AURORA
ALL AUV20AWHT MODELS 1B73385
8/2020

1

a. Base
b. Water tank
#1B73182
c. Nozzle
#AUVN
d. Water tank cap
#AUCAP
e. Demineralization cartridge (attached to the tank cap)
#AU5003PK
f. Essential oil tray
#AUTRAY
g. Essential oil pads
#AURP10PK
h. Owner’s manual
#1B73385
Remove the AURORA from its packaging.
You should have:
1
a
b
c
d
f
g
e
h
LET’S GET YOU UP AND RUNNING
Prefer to see a video?
Watch the AURORA set-up at
aircareproducts.com/support.
SCAN THE CODE TO THE RIGHT
WITH YOUR PHONE’S CAMERA
If you are missing any parts, or need
replacement parts, call us at 800.547.3888
or visit our website aircareproducts.com.
♥We hope you love your AURORA. 2

Remove the cap and the attached
demineralization cartridge from the
water tank. Your demineralization cartridge helps
break down the minerals naturally found in water
– improving your air quality and preventing the
white dust people sometimes notice with ultrasonic
humidifiers.
Fill the water tank, then screw the cap back on,
making sure the cap is correctly threaded. Your
AURORA holds 1 gallon of water.
Put the water tank on the base with the
AIRCARE logo over the control knob, then
put the top nozzle on the tank.
2
3
About water additives:
• Do not add essential oils directly to the AURORA water tank.
Only add them to the essential oil tray.
• Do not use water softeners.
3

Put your AURORA on a level surface in the
room where humidity is most needed. To
avoid condensation, make sure the unit is at least
two inches from the wall and not under a window.
4
Note: The AURORA is an ultrasonic humidifier, so it emits a very fine
mist. Position the nozzle to direct this mist away from furnishings and
electronics.
To add essential oils, remove the essential
oil tray from the side of the AURORA base.
Add a few drops of essential oil to the tray pad. Add
more oil to your liking. Only use essential oils in the
tray; any brand will work with the AURORA.
5

7
6
Plug in your unit and turn the control knob
to the right to turn on the AURORA. The
power light will glow green. Set your desired mist
output level by turning the knob to the right (higher)
and left (lower).
Select the nightlight color by pressing the
LED button on the front of the AURORA.
• first press: the colors rotate
• second press: holds the current color
• third press: purple
• fourth press: blue
• fifth press: teal
• sixth press: green
• seventh press: yellow
• eighth press: orange
• ninth press: red
• tenth press: nightlight o
That’s it! Your AURORA is ready to use.
Note: For your first use, run your AURORA at full output until the unit is
empty. The power light will glow red when the AURORA is out of water
and mist output will stop until you refill the humidifier. The nightlight will
continue to glow even when the AURORA is empty.
6
7
5

Regular cleaning is important for preventing mold,
mildew, and other bacterial growth in your humidifier.
It also keeps your AURORA working its best.
1. Let the unit run until it’s empty, then turn it o and unplug it.
2. Remove the water tank and unscrew the cap. Throw your
demineralization cartridge away if it is time to replace it.
Otherwise, put it in a sink while you finish cleaning your
AURORA.
3. Pour out any remaining water from the tank.
4. Fill the tank a little more than half-full with water and add 2
tablespoons of white vinegar. Pour a little of this vinegar-
water mixture into the base.
5. Put the water cap back on, shake the tank gently, then let sit
for 20 minutes.
6. With the mixture in the base, use a soft cloth to clean the
inside of the base. Gently scrub the oscillator (the dark ring in
the basin). Let sit for 20 minutes.
7. After 20 minutes, empty the water tank and base.
8. Dampen a sponge with white vinegar and wipe down the
base, tank, tank nozzle, and cap. Rinse everything thoroughly.
9. Wipe everything dry and replace the demineralization
cartridge, if needed. Then reassemble.
When storing your AURORA, discard the used demineralization
cartridge (keep your cap) and clean the unit as described above.
Dry the unit thoroughly, and store in a temperature-regulated area.
Do not install a new demineralization cartridge until you are ready to
use your humidifier again.
HOW TO CLEAN YOUR AURORA
6

Q
Q
Q
Q
Q
Q
[e-mail] aircareproducts.com 800.547.3888
AURORA
R
R
R
R
R
R
TOUS LES MODÈLES AUV20AWHT
Tout ce que vous devez savoir sur votre
Lisez et conservez ces instructions
FOIRE AUX QUESTIONS
Pour toute autre problème, contactez nos experts en humidification!
Ils sont prêts à vous aider par téléphone, courriel ou chat.
Où se trouve mon numéro
de série?
Pourquoi mon unité
produit-elle très peu de brume?
Pourquoi le bouton de mise en
marche est-il rouge?
Puis-je commander des
pièces de rechange?
Dois-je utiliser une cartouche
de déminéralisation avec mon
AURORA?
Pourquoi y a-t-il de la poussière
blanche autour de mon
humidificateur?
Votre numéro de série se trouve sur l’autocollant au bas de
votre appareil. Vous pouvez l’écrire ici pour référence future :
__________
Votre AURORA s’arrête de fonctionner et le bouton de
mise en marche devient rouge lorsqu’il n’y a plus d’eau.
Oui! Les pièces de rechange AURORA et leurs
références sont indiquées à la page 10.
Votre AURORA fonctionnera très bien sans la
cartouche, mais vous pourriez remarquer une poussière
blanche autour de votre appareil. La cartouche aide à
décomposer les minéraux naturellement présents dans
l’eau qui sont à l’origine de cette poussière blanche.
La poussière blanche est le résultat de minéraux
naturellement présents dans votre eau. Elle est inoensive.
• Assurez-vous que vous n’utilisez pas d’adoucisseur
d’eau dans votre AURORA.
• Installez une cartouche de déminéralisation (#AU5003PK).
• Tournez la sortie de brume vers le haut.
• Assurez-vous que l’oscillateur est propre.

AURORA
1B73385
8/2020
TOUS LES MODÈLES AUV20AWHT
Tout ce que vous devez savoir sur votre
Lisez et conservez ces instructions

9