Airconet FC240 User manual

110-220VAC Fan Coil and HAU Thermostat installation guide
Model: Airconet-FC240
1. Remove the back panel using flat object
2. Mount thermostat’s back cover
at upright position on the wall.
Cut cover and insert AirCon wires
3. Disconnect main power breaker and wire thermostat as follows:
4 pipes (2 valve) 2 pipes (1 valve)
Caution 1: the 5 outputs are ‘Live’
Caution 2: Ensure AC switching is on Live (otherwise swop L and N)
4. Attach the thermostat to the back panel by pushing it onto the wall.
Ensure it is tightly mounted all around (confirm there is no gap)
5. Connect power supplies back
6. Press the thermostat’s power button to ensure the thermostat is
connected properly. The display should show the room temperature
Up
Screws
Cut out

7. Setup the thermostat:
a) oC →0F 
Temperature mode select:
oF is Fahrenheit (not compatible with App)
oC is Celsius (default)
b) P4 →P2 
Select AirCon Type:
P2 is 2 pipes aircon
P4 is 4 pipes aircon (default)
c) FA →F1 →FC 
Fan Logic:
FA - Automatic Fan (fan stop when aircon reaches the set point)
F1 - Fan Always On (no matter what is the set point)
FC - Fan work only in Cool mode (fan stop when aircon reaches set point but not in heat mode)
d) E1 →E2 →E0 
Set point limiting range:
e) L1 →L2 →L3 →L4 →L5
AirCon brand IR code selection (optional)
App Setup
New thermostats have red light flashing indicating the thermostat is
not connected to the network. After successful connection to internet
the red light should be normally OFF
Follow the instruction on: http://www.airconet.net/ap
Note: to reset the thermostat network manually, switch off thermostat and
then press and hold the up/down button 10 seconds until all light are off
oC
oF
E1 (default)
16-32
60-90
E2
18-30
65-85
E0
5-35
40-95
a) Press to Power On thermostat
b) Hold + for 3 sec. to enter setup (light will flash)
c) set ‘parameters’ with 
d) press to change setup mode
e) Follow setup bellow