AIRFLO AFV618 User manual

Instruction Manual
Hush Power
AFV618

Know your vacuum cleaner

Important safety instructions
Do not use for absorbing detergent, kerosene,
glass, needle, cigarette ash, water, match etc.
The appliance should not be exposed to heat
Do not vacuum any moist or liquid substances ,
Never immerse the appliance in water.
Unplug the appliance from the mains supply
Socket after use and before every cleaning pull
the mains cable, in order to disconnect the
appliance from the mains
This appliance is not intended for use by
persons (including children) with reduced
physical,
sensory or mental capabilities, or
lack of experience and knowledge, unless they
have
been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure
that they do not play with the appliance
If the supply cord is damaged, it must be
replaced by the manufacture or its service
agent or a similarly qualified person in order to
avoid a hazard. For household use only

Important safety instructions
Do not put any object into openings. Do not
use with any opening blocked. Keep the
appliance free of dust, lint, hair etc.
Do not use the vacuum cleaner without dust
container or dust filter in place
Do not vacuum any flour, cement etc, in order
to avoid the overloads.
The appliance should only be cleaned with a dry
or damp cloth ,it should never immersed in water.
Do not use any solvents for cleaning

Assembly vacuum cleaner
Connect the hose with vacuum cleaner
Insert flexible hose into the air-intake:
Press the knob until it clicks into the position
Remove the flexible hose:
Unplug the appliance and press the knob at the end of the hose
Remove it from the air-intake opening.
Fit the telescopic to the angled pipe
Fit the floor brush to the telescopic tube

Operation
●A yellow mark on power co
rd shows the ideal cable
length. Do not expend the cable beyond the red mark
●To rewind the power cord, press the rewinder pedal
with one hand and guide the cord with the other hand
●press the power switch to switch the appliance on.
●
Use the electronic speed adjusting to control the
suction power of the cleaner
●
Set the required suction power by means of the
electronic suction regulator
●The suction power can be adjusted with the sliding
control on the angled pipe too
• If the suction flow is interrupted or the dust bag is full,
the indicator lights up red. Turn off the machine
immediately, and clean the inlet filter. Empty the dust
bag. Turn the unit on again
• Note: Pay attention to unusual noises when using the
device.
This could indicate a malfunction or a
blocked suction.

Cleaning tools
●Crevice tool:
For cleaning corner edge and draws etc:
Where is difficult to reach, such as gaps and the
keyboard, bookshelf and windows
●Sofa brush:
For cleaning bed, sofa, couch etc.
Use of the selector on floor brush :
Bristles extended for carpets.
Bristles retracted for hard floors
●If the angled pipe has blockage
Insert it into the air-intake and
switch the appliance on

Cleaning and maintenance
●Empty the dust container
⑴After removing the flexible hose ,press the cover
lock button and open the dust container
⑵Remove the dust filter form the container
⑶Replace the dust filter in the container.
⑷Close the dust container until it is locked in the position
r
●
Change filter
Replace the motor filter: Replace the outlet filter:
Open the dust container and remove the motor Detach the grille by pulling firmly away from
filter. Fix the new filter in the position the appliance, remove the outlet filter and
replace the new filter. Fix the grille again
Clean the filter
Clean the motor filter in water and allow them
to dry completely before replace
them.

Error detection:
Before you contact our services center, please check the following points
Problem Possible reason Active
Motor does not start
-Power card not firmly
plugged into outlet
-Outlet damaged
-Cleaner not switch on
-Plug unit firmly
-Check the outlet
-Switch on the appliance.
Suction power is weaker
-unit clogged
-Dust filter needs
cleaning
-Du
st container not in
position
-Filter blocked
-Remove the blockage
-Clean the dust filter
-Close the dust container
-Clean the filter
The wire can not be
winded completely .
The wire may diverge
the wire wheel.
Draw the wire a little then
rewind.
The wire can not be draw
out.
The wire may wind
disorder
Press the rewinder
button and try again.
Speed adjust does not
work
Appliance is defective
Repair the appliance
(only specialist)
Power card winds
unwanted back
Rewind mechanisms is
defective
Repair the appliance
(only specialist)
The dust container can
not be closed
Dust filter is not in the
position
Fix the dust filter and try
again
Warming:
If the supply card is damaged, It must be replaced by the
manufacturer or its server agent of a similarly qualified person in
order to avoid a hazarded.

Technical data
Rated voltage: 220-240V AC
Rated frequency: 50/60Hz
Power:
VL-614E-A 750W
Operating pressure: >18.0kPa
Sound level: <76dB(A)
Operating radius: 7M
Correct Disposal of this product
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm
to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe
recycling.
Warranty information
The manufacturer provides warranty in accordance with the legislation of the
customer’s own country of residence, with a minimum of 1 year (Germany:2
years).starting from the date on with the appliance is sold to the end user.
The warranty only covers defects in material or workmanship.
The repairs under warranty may only be carried out by an authorized service centre.
When making a claim under the warranty, the original bill of purchase (with purchase
date) must be submitted
The warranty will not apply in cases of:
-Normal wear and tear
-Incorrect use, e.g. overloading of the appliance, use of non-approved accessories
-Use of force, damage caused by external influences.
-Damage caused by non-observance of the user manual, e.g. connection to an
unsuitable mains supply or non-compliance with the installation instructions
-Partially or completely dismantled appliances

Packing list &circuit diagram
●packing list
quantity model NO,
name VL-614E-A
vacuum cleaner body 1
tubes 1
Floor brush 1
brush nozzle 1
Sofa brush 1
instruction manual 1