Airwheel SE3T User manual

SE3T
USER MANUAL

- 01 -
SE3T 1 charger 1
Instruction manual 1 Power bank 1
Packing List
SE3T
Power bank
Instruction manual
Charger
使用指南
SE3T
Thank you for buying the Airwheel SE3T Smart Rideable suitcase.
Please read the product instructions carefully before using the Airwheel SE3T and follow all
instructions, notes and warnings in this manual. Failure to do so will result in damage to the product
and will not be covered by the warranty.
Please keep the manual and warranty card in a safe place.
Products and accessories

- 02 -
SE3T Diagram
Motor wheel
LED light
TSA coded lock
Handle
Steering lever
button
Brake handle
Rear wheel
Power button
Acceleration
USB charging
Lift grip
Pull rod
Power bank

- 03 -
Motor size 5.5inch Motor number 1
Motor power 250W
Size 520X270X605mm Vehicle weight 9kg
Volume 48L Maximum load 110kg
Lock type TSA coded lock Maximum climbing angles ~ 6 °
Rear wheel 6inchX2 Applicable temperature -10℃~40℃
Front wheel 5.5inch Maximum speed 13km/h
Material Shell ABS+PC
Aluminum alloy frame
USB output voltage 5V
Specications
Main specications
Battery specications
Motor specications
Battery capacity 73.26Wh Charging time 2h
Battery type lithium Battery voltage 37V
Removable Ye s Charging voltage AC100-240V 50-60Hz
Warning
Please don't dispose of used batteries to avoid environmental pollution. The used lithium battery of this product
is responsible for recycling by the company or distributors and government designated sites.

- 04 -
1-2
1-1
Use SE3T
SE3T-riding mode
1.Hold the steering lever button and pull the steering lever up;
2.Turn on the power supply (see Figure 1-2), sit on the riding box, put your feet on both sides of the foot
position, look ahead, ready to start;
3.Turn the acceleration switch forward, turn the brake switch to brake, turn the brake switch to loosen and then
turn the acceleration switch to reverse (see Figure 1-1);
4. When the ride ends, turn off the power. Hold the steering lever button and put the steering lever down.
Normal mode
Riding mode
Acceleration
switch
Steering
lever button
Brake lever
Pedals
Power button
Turn the brake lever to brake
ReverseForward
Sitting on the riding box, placing
your feet on the pedals, turning the
acceleration and turning forward
Turn the brake switch and
turn it off and then turn the
acceleration switch to reverse
Brakes

- 05 -
1-3
1-5
1-4
Power
bank
card
slot
Pull
rod
SE3T- Normal Mode
1.Turn off the power, pull out the lever, you can drag
(see Figure 1-3);
2. Pick up the "hands-on" and carry them (see gure 1-4).
1. Check if the power is sufcient and the brakes are in good
condition before riding.
2. Before rst use, it is recommended to charge to full power.
3. It is not recommended to brake or turn sharply during the ride to
prevent side slipor or rollover.
4. Please observe the trafc rules and various site management
regulations during use.
5. Avoid using this product in bad weather such as rain, snow or ice.
6. When not in the riding mode, turn off the power.
Riding precautions
Power bank use
Power bank installation
Pull up the pull rod and insert the power bank
along the card slot.
Note: When installing the power bank, please
install it in the direction shown in Figure 1-5,
with the front facing outward.
Power bank disassembly
Turn o󽗈 the power, pull up the pull rod, and pull the
power bank out of the card slot.

- 06 -
Power bank use
If the factory time is short, the user can use the product directly. If the factory time is longer (more than 2
months), the power will be lost during storage and transportation. The battery should be recharged before use.
Do not charge with other brands of chargers.
The Power Bank contains high-voltage circuits inside, and the factory has been packaged intact. Do not
disassemble or disassemble it.
Use and store to prevent liquid and metal particles from penetrating into the interior of the Power Bank.
Power Bank can not be close to open flame or high temperature heat source, but can not throw the
powerbank into the water. In the hot season, it is strictly forbidden to charge the power bank in the sun.
It is strictly forbidden to short-circuit the positive and negative poles of the Power bank with wires or
conductors to avoid danger and damage the power bank.
Power bank need to be handled with care, to avoid collisions falling and falling, in order to prevent damage
to the casing and accidents.
When charging, keep it in a safe place that children cannot touch.
It should not be used without full charge.
Do not cover anything when charging the battery.
In case of long-term use, it needs to be fully charged and placed. It can not be more than 3 months from the
last charge, so it needs to be recharged and placed.
To charge the Power Bank, you need to take out the Power Bank rst, then insert the matching charger into the
power bank input interface (DC charging port), and then connect the AC100-240V power supply (commercial
power).During the charging process, the charger indicator light is red; after the Power Bank is fully charged, the
charger indicator light is green.
Power Bank use precautions
Charging Power Bank
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
USB output interface
Input/output interface
Click to view the Power
bank indicator, 5 grids are
full, decrementing, red or
indicating that the battery
is insufcient to charge in
time.
For charging mobile phones
and digital products with DC-
5V input charging, please
select the original charging
cable for the charging cable.
DC charging port
Power View Switch
Power
bank
card
slot

- 07 -
Safety
For all the precautions in the SE3T riding, please be sure to read and ride the SE3T as required. Do not use
this product until you have read the instructions carefully to understand the performance of SE3T; do not lend to
anyone who does not manipulate this product.
It is strictly forbidden to accelerate, decelerate and sharply turn. It is strictly forbidden to ride at speed (the speed
is too fast); please keep at a low speed during the riding. If there is a risk of falling, please protect your personal
safety and do not consider the SE3T. The SE3T may cause wear and tear during riding and parking, which may
affect the performance of the product. Therefore, before you ride the SE3T, you must do the following checks:
Power switch indicator
Flash 1: Motor stall
Flash 2: Low battery
Flash 3: Turn the fault
Flash 4: Battery undervoltage
Power button
The original password is 0-0-0, set your own password,
follow these steps:
1.Dial the password to the original password: 0-0-0;
2.Press the button A with a pen or other tool until you
hear the 'tick' sound;
3.Dial the password wheel B to set your own password,
for example: 8-8-8;
4.Push button C in the direction of the arrow and hear the“tick”
sound again. Button A pops up and the password is successfully set.
Now you have completed your password setup, please keep it in
mind. If you need to reset your password, repeat the above steps.
Custom coded lock instruction
Other maintaining
Appearance cleaning
Vehicles need to be cleaned at any time.
When cleaning dust, do not wipe the electrical parts and connectors with a damp cloth.
1.
2.
Lubricate the front and rear axles once every six months.
Check and tighten contact of electrical connectors.
Whether the brake is workable.
1.
2.
3.
Maintaining
Very important

- 08 -
It is necessary to check whether the various components of the SE3T are securely installed, without
damage, and the brake function and tires are in good condition.
You need to fully understand the surrounding cycling environment: make sure you are not disturbed by cars,
pedestrians, pets, bicycles and other obstacles.
1.
2.
Power button
All rights reserved in this manual shall be the property of the company.
Note:
Do not store cash or valuables in your suitcase.
The safety and reliability of brakes, boxes, wheels, wheels, etc. must be conrmed before riding to avoid
accidents.
Avoid riding on uneven, muddy, rocky roads, slippery roads, waterlogged roads and stairs to prevent rim
deformation and danger.
The torch can not be hung on the ride, so as to avoid the operation of out of control accident.
This product is suitable for one person riding.
Overloading and crawling ramps greater than 15 degrees are strictly prohibited.
People who are still under the force of drugs or alcohol, have limited mobility and responsiveness are
prohibited from riding.
Riding is prohibited in cases where it is not suitable for riding due to the cyclist's own reasons or other
objective factors.
It's important to get the habit of charging in time every day, when you ride with a minimum allowed voltage
before you can keep your battery in place for longer, so it's important to get into the habit of charging in
time every day. Almost all kinds of batteries are affected by the environment. In general, the discharge
performance of electricity is better when the temperature is higher, and when the temperature drops below
0C, the battery's power may drop by more than one-third.
Therefore, when winter comes or in cold areas, the reduction of the mileage after a single charge is normal,
when the temperature rebounds to more than 20 degrees Celsius, its function naturally recovers. Remove
dust from the power plug regularly.
Ash accumulation in humid environments such as may cause re hazards. Do not damage, force bend, or
bundle the power cord.
Do not place heavy objects on the power cord or expose them to places that emit excessive heat.
Do not insert foreign objects at USB ports, charge-discharge connectors, or other openings of the product.
Do not split the individual parts of the suitcase yourself.
Do not lift the suitcase with a lever handle. Lift the suitcase when crossing the steps or steps.
Pulling the suitcase over the steps or steps can cause the suitcase to tip over and damage.
In a moving car, uneven or sloping place, place the suitcase on the ground to prevent it from tipping over
and damaging. Do not place the luggage in a damp and unventilated and acidy environment for long periods
of time. If wet by the rain, please dry it in time.
Prohibit the placement of suitcases in high temperature, reworks.
Do not wipe the suitcase with corrosive solvents such as banana water and petroleum concentrate.
Do not rinse directly with water and use it in rainy days.
When closing the suitcase, be aware that your body or clothes should not be caught in the case or locked.
Be careful of liquid leaks in the luggage, which may cause a short circuit in the inner compartment.
The Company is not responsible for prohibiting the use of charging cables and other accessories that are
not exclusively designed by the Company and in the event of an accident.
Unauthorized removal or modication of this suitcase is prohibited, and the Company will not be liable for
the resulting damage and may deprive you of your warranty commitment. In the event of an internal failure,
contact the aftermarket personnel.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.