Akai AK-VTD0901 User manual

DESK VENTILATOR
(220-240V / 50Hz)
AK-VTD0901 AK-VTD1201
OPERATOR’S MANUAL
OPERATOR’S MANUAL 1 ~ 4

2
OPERATOR’S MANUAL
CAUTION
1. Don’t put the AC plug into the wall outlet until the fan
has been completely assembled.
2. Use power supply of the fan according to the electric
nameplate at the back of switch box.
. Don’t insert fingers or other objects through the guards
when the fan is working.
4. Unplug the power supply when moving from one place
to another or when the fan needs cleaning.
5. Household and indoor use only.
6. Assure the fan to be on a stable surface when operating
to avoid overturning.
7. Voltage is 2 0V, frequency is 50Hz.
1. Front Guard
2. Blade Nut
. Blade
4. Guard Nut
5. Rear Guard
6. Motor
7. Oscillation Knob
8. Cord
9. Switch
PARTS IDENTIFICATION

3
Rear Guard Assembly
Pull out the fan body from the box. Remove the plastic
guard nut from the motor shaft. Then insert the rear guard
into the front side of the motor shaft. Make sure that the
central holes on the guard must fit the plastic pins around
the shaft. Insert the guard nut and rotate it clockwise to
lock the rear guard. (As shown in Fig.1)
Fan Blade Assembly
Insert the blade into the motor shaft. Make sure that the
stopper pin is clipped into the groove of the blade. Then,
insert the blade nut onto the blade center and rotate it
anti clockwise to tighten the blade. (As shown in Fig.2)
Front Guard Assembly
Cover the front guard onto the rear guard by slipping the
edge of the front guard into the other slot of the guard ring.
Then tighten the bolt in the joint of the guard ring by
screwdriver. (As shown in Fig. )
Adjust the fan head to the desired angle by holding the
fan head and pushing the fan guard upward and
downward position.
Speed is controlled by pressing the key.
ASSEMBLY AND OPERATION

4
1. Use wet cloth with detergent or dry cloth to wipe the
fan.
2. Don’t swill be fan with water.
. Never open the cover during cleaning. No user
serviceable parts inside.
4. Cover it with a plastic bag, and lay it in dry place or box.
5. Be sure to unplug the power supply before cleaning.
6. Only use soft wet cloth to clean the parts.
7. Go by the order of assembly to disassembly each part.
8. Never use petrol or other chemicals to wipe it when
cleaning the fan.
9. If the power cord is damaged, to avoid the danger, it
must be replaced by the manufacturer or its repair shop
or the similar professional person.
MAINTENANCE
According to Waste of Electrical and Electronic
Equipment (WEEE) directive. WEEE should be
separately collected and treated. If at any time in
future you need to dispose of this product please do
NOT dispose of this product with household waste.
Please send this product to WEEE collecting points
where available.

5
AKAI ELECTRIC CO.,LTD. JAPAN
www.akai.com