SAFETY INSTRUCTIONS
Read all instructions before you use this projector. Do not make any changes or create
settings that are not described in this manual. If physical injury, loss of data or damage is
caused by failure to follow instructions, the warranty does not apply.
CHARGING
• The output voltage/current of the adapter is DC 5V 3A and the input voltage/frequency
is AC100-240V, 50/60Hz.
• When charging, place this device in an environment that has a normal room temperature
(ranges from 5°C to 25°C/41°F to 77°F recommended) and good ventilation.
BATTERY
• Do not replace the built-in battery yourself. Contact an authorized service center to
replace it.
• The remote control contains 2 x AAA batteries, keep the remote control out of reach
children.
• Risk of explosion! Keep batteries away from heat, direct sunlight or fire. Never dispose of
batteries by burning.
• When the remote control is not used for a long period of time, remove the battery.
• Replace the remote control battery only with the same or an equivalent type.
• Batteries contain chemical substances and should be disposed of properly.
• Charge this device regularly. Do not store this device with a completely discharged
battery.
SETUP
• To reduce the risk of fire and/or electric shock, do not expose the device to rain or
moisture. Objects filled with liquids, such as vases,should not be placed on this device.
• Do not place this device on soft surfaces such as tablecloths or carpets, otherwise the
device could be fire hazard.
• Do not place this device in areas susceptible to excessive dust and dirt or near any
appliance generating a strong magnetic field.
• To prevent overheating do not block or clog the ventilation openings.
• Never place this device in a confined space. Always leave enough space around this
device for ventilation.
• Protect this device from overexposure to direct sunlight,heat,large temperature
fluctuations and moisture. Avoid extreme temperatures. The suitable operations and
storage temperature for this device and its accessories is 0°C to 35°C/0°F to 95°F
• When this device is running for a long period of time, the surface may become hot. Shut
it down immediately and unplug the charger. Resume operation after this device has
cooled down.
• Always handle this device with care. Avoid touching the lens. And do not look directly
into the lens to avoid the strong light hurt your eyes.
Note: When projector is working, please do not look directly into the lens, the strong light
will flash your eyes and cause slight pain if your eyes are close to the lens. Children should
use the projector under the supervision of adults.
CLEANING
• Use a soft, lint-free cloth. Never use liquid, gaseous or easily flammable cleansers(sprays,
abrasives, polishes,alcohol) to clean.
• Do not use any liquid cleaning agents to clean the lens to avoid damaging the coating
film on the lens. Use lens cleaning paper to clean the lens.
REPAIRS
• Do not make any repairs to this device yourself. Only have your device repaired by an
authorized service center.
• Improper maintenance can result in injuries or damage to this device.
• Refer all servicing to qualified service personnel.
CAUTION
• Possibly hazardous optical radiation emitted from this device.
• Do not stare at the operating beam. The bright light may damage your eyes.
01 02
