Alarmcom Smart Gateway ADC-SG130 User manual

Connect a video device to an ADC-SG130 using Wi-Fi Protected Setup
(WPS)
The Smart Gateway's Wi-Fi Protected Setup (WPS) button allows video devices to connect to its dedicated network. The
customer's Wi-Fi name and password are unneeded for this connection method.
Important: The Smart Gateway must be enrolled on the customer's account before it can connect to video devices. For
more information about enrolling the Smart Gateway, see Smart Gateway (ADC-SG130) - Installation Guide.
To connect a video device to the ADC-SG130 using physical buttons:
1. On the Smart Gateway, press and hold the WPS button for approximately 1 to 3 seconds. The Wi-Fi LED will
slowly flash to indicate that the device is in WPS mode.
2. Trigger WPS on the video device. For more information about triggering WPS on a specific video device, see the
device's installation guide in Video Devices.
3. Wait 2 minutes for the video device to connect. If the connection is unsuccessful, WPS mode times out after 2
minutes.
To connect a video device to the ADC-SG130 using the MobileTech app:
1. Log into the MobileTech app.
2. Find the customer account.
3. Tap Equipment.
4. Tap Access Points.
5. Tap the desired Smart Gateway.
6. In Additional Commands, tap Trigger WPS.
7. Wait for the Smart Gateway to go into WPS mode.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/Smart_Gateway_(ADC-SG130)/Co…
Updated: Mon, 14 Jun 2021 20:34:33 GMT
1

8. Trigger WPS on the video device. For more information about triggering WPS on a specific video device, see the
device's installation guide in Video Devices.
9. Wait for the video device to connect. If the connection is unsuccessful, WPS mode times out after 2 minutes.
To connect a video device to the ADC-SG130 using the Partner Portal:
1. Log into the Partner Portal.
2. Find the customer account.
3. Click Equipment.
4. Click Access Points.
5. Using the Smart Gateway dropdown menu, select the desired Smart Gateway.
6. Click Trigger WPS.
7. Trigger WPS on the video device. For more information about triggering WPS on a specific video device, see the
device's installation guide in Video Devices.
8. Wait for the video device to connect. If the connection is unsuccessful, WPS mode times out after 2 minutes.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/Smart_Gateway_(ADC-SG130)/Co…
Updated: Mon, 14 Jun 2021 20:34:33 GMT
2