alberta EUROSEC User manual

1
INSTRUCTIONS
MANUAL
EUROSEC
V. 2019.001

A
B
C
D
G
FE

How do I switch on/activate the alarm system?
Press button Cand leave the premises immediately.
Enter the 4 digit code followed by the button Aand leave the premises immediately.
How do I switch off the alarm system?
Enter the 4 digit code only.
How can I change the code?
Enter the 4 digit code, press G times 3, press E, press G, press E, select which code to edit between 1 to 9, press G,
enter your desired 4 digit code & press E. Press button F for 3 times.
If I am in a panic situation and I need to call for help,
what can I do?
Press button 1& button 3simultaneously and keep them pressed for 2 seconds.
If the alarm rings,
how can I know which sensor triggered it?
Enter the 4 digit code to switch off the system. System will show you the exact zone which has been triggered.
Enter the 4 digit code to switch off the system and if the alarm shows !!!!CHECK!!!! on display,
press the 4 digit code again and press button F .
What do I have to press if there is a power cut to make
sure that my alarm is set properly when the electricity
is back on?
Enter the 4 digit code and press button D.

How long does my battery backup last,
in the event of a power fail?
Usually between 6 & 8 hours. It also depends if a maintenance service has been done in the last 2 years.
I am thinking about changing my telephone provider, will it
affect my alarm system?
It is very important to speak to Alberta technical representative to guide you way forward.
Can I add additional devices to my existing alarm systems
and how do I go about doing so?
Usually YES, but it also depends on the type, brand and amount of devices needed to be added.
Can I order a single alarm remote?
This type of alarm doesn’t take remote controls.
Keep in Mind! Service your alarm every year to make sure that the
system is functioning properly.