Aleko BSW03 User manual

Dual Swing Set - BSW03
www.aleko.com

Frame Assembly
BEFORE ASSEMBLING: Please read and abide by all Safety Guidelines, and
confirm all necessary parts are included by referencing parts list on page 1.
Step 1. Place together the short curved ends of the Left-Hand Top Leg and Right-
Hand Top Leg and insert into the Top Bar.
Step 2. Place 1 F1 fastener in vertical hole in Top Bar assembly and tighten
securely.
Swing Assembly
Step 1. Completely disassemble S1 U-Bolts then place u-shaped bolt through
the hole in the bearing assembly found at the end of the Swing Ropes.
Step 2. Tighten open-ended S1 nut down onto u-shaped bolt, place 1 S1 washer
on each end of the bolt and insert into Top Bar through 2 sets of vertical holes.
Ensure washer placement between nuts and Top Bar.
Step 3. Place 1 S1 washer on the exposed threaded ends of the S1 bolt, then
attach S1 cap nuts and tighten down. Repeat for both sets of Swing Ropes.

Step 4. Insert 1 Bottom Leg into the open end of each of the 4 Top Legs. Place a
F2 fastener into each of the holes at the junction, making sure the exposed
threaded end is pointed away from the Swings.
Step 5. Place Side Stay Bar over the exposed fastener ends so that the flat side
of the Stay Bar ends is in contact with the Top/Lower Leg assembly.
Step 6. Tighten F2 nut down onto Side Stay Bar.
Anchoring Swing Set to Ground
Step 1. Attach Ground Pegs to all 4 Nest Swing Bottom Legs using P1 fasteners.
Step 2. Place assembled Swing Set in desired location and dig a footing hole,
measuring 12" (30cm) Long x 12" (30cm) Wide x 20" (50cm) Deep, at the base
of each support leg.
Step 3. Prepare and pour concrete into the footing holes following concrete
manufacturer's instructions. Fully fill footing holes to be level with ground surface.
Step 4. While Concrete is still wet, angle Ground Pegs toward swingset Top Bar
at roughly 120-degrees, then insert Ground Pegs into concrete footing, making
sure Swingset Bottom Legs do not sink below ground surface (utilize concrete set
time information). Use temporary support made from wood or other material if
necessary to prevent sinkage.
Swing Set will be ready for use once concrete is fully set and cured (consult
concrete manufacturer's instructions).
Visit www.aleko.com for Tech Support, Customer Service and more great
products for your Home, Garden, Patio, and Pets!