Aleko BSW07 User manual

5
16
35
7
5
35
5
35
5
16 F5
F6
F6
F6
16
7
7
5
5
5
M8 BOLT 53mm (X1)
M6 BOLT 50mm (X8)
M8 BOLT 60mm (X4)
F5
(x4)
(x4)
F5
Nest Swing - BSW07
www.aleko.com

5
16 F5 16
7
7
5
5
5
M8 BOLT 53mm (X1)
M6 BOLT 50mm (X8)
M8 BOLT 60mm (X4)
F5
(x4)
(x4)
F5
Step 1. Insert tapered end of Top Bar 1 into the end of Top Bar 2.
Make sure there is only 1 set of holes in the end connected to Top
Bar 1.
Use 1 F2 fastener to connect Top Bar 1 to Top Bar 2
**Always Make sure to place included washers between
fastener head or nut and adjoining swing components**
Step 2. Insert 1 Top Leg segment into either side of the T-shaped
Connector, secure with 2 F3 fasteners per Leg. Repeat for both
Connector and Top Leg assemblies.
Step 3. Insert either end of assembled Top Bar into Connecter and
Leg Assemblies. Use 2 F5 fasteners on each side to attach.
Step 4. Completely disassemble F1 U-Bolts then place u-shaped
bolt through the hole in the bearing assembly found at the end of the
Swing ropes.
Tighten open-ended F1 nut down onto u-shaped bolt, place 1 F1
washer on each end of the bolt and insert into Top Bar through 2
sets of vertical holes. Ensure washer placement between nuts and
Top Bar.
Place 1 F1 washer on the exposed threaded ends of the F1 bolt,
then attach F1 cap nuts and tighten down. Repeat for both sets of
Swing ropes.
Step 5. Insert 1 Bottom Leg into the open end of each of the 4 Top
Legs. Place a F4 fastener into each of the holes at the junction,
making sure the exposed threaded end is pointed away from the
Nest Swing.
Place Side Stay Bar over the exposed fastener ends so that the flat
side of the Stay Bar ends is in contact with the Top/Lower Leg
assembly.
Tighten F4 nut down onto Side Stay Bar.

5
16
35
7
5
35
5
35
F6
F6
F6
Nest Swing - BSW07
Anchoring the Gym to the Ground
Step 1. Attach Ground Pegs to all 4 Nest Swing Bottom Legs using F6
fasteners.
Step 2. Place assembled Swing Set in desired location and dig a footing
hole, measuring 12" (30cm) Long x 12" (30cm) Wide x 20" (50cm) Deep,
at the base of each support leg.
Step 3. Prepare and pour concrete into the footing holes following
concrete manufacturer's instructions. Fully fill footing holes to be level
with ground surface.
Step 4. While Concrete is still wet, angle Ground Pegs toward opposing
legs at roughly 120-degrees, then insert Ground Pegs into concrete
footing, making sure Swing set Bottom Legs do not sink below ground
surface (utilize concrete set time information). Use temporary support
made from wood or other material if necessary to prevent sinking.
Swing Set will be ready for use once concrete is fully set and cured
(consult concrete manufacturer's instructions).
Visit us at www.aleko.com for Tech Support, Customer Service,
and more great products for your Home, Garden, Patio and Pets!