Alera Plus AAP-CP110 Configuration guide

123456
1PC 1PC 1PC
1PC
PARTS LIST
1PC
1PC
78
4PCS
9
6PCS
10
5PCS 1PC
11
4PCS
12
1PC
S T E P 1
S T E P 4
S T E P 2
3
S T E P 3
6
7
54
2
8
10
11
9
12
ASSEMBLY INSTRUCTIONS
Read these instructions efore starting; follow assem ly
procedures carefully.
1. Install casters ⑦into each of the legs of the ase ⑥.
Be sure each caster is completely inserted into leg for
proper sta ility.
2. Insert the lift assem ly ⑤into ase with tapered-end
down. Secure lift assem ly y applying a little downward
pressure. Remove yellow plastic cap from top of lift
assem ly. DO NOT PUSH ON BUTTON AT THE TOP!
3. Slide dust cover ⑫onto lift assem ly.
4. Turn seat ② upside down on corner of workbench or
table with back of seat towards you.
5. Attach left and right armrests ③ and ④ to bottom of
seat using three pan head screws with washers ⑧ for
each armrest. Armrest pads should be parallel to sides
of seat. Depending on size of end-user, armrests can be
adjusted close to or away from sides of seat. Tighten
screws securely.
6. Turn ack ① upside down and align back bracket with
holes in seat ②. Attach back bracket using four socket
head bolts ⑪ with hex wrench ⑩. Before tightening
make sure gap between seat and back is the same on
both sides. Securely tighten four bolts.
7. Align two holes in ack plastic strap with two holes in
seat and securely tighten with two phillips pan head
screws ⑨. Attach back plastic strap on other side of seat
with remaining two screws ⑨ and make sure all four
screws are securely tightened.
8. Install seat with control assem ly ②y aligning hole on
the control with the shaft of lift assem ly. Push down
firmly on seat. Handle on control can e pulled up to
raise and lower seat.
6. When sitting on seat, pull up on handle to lower seat. To
raise seat, remove weight from seat and pull on seat
handle.
GENERAL SAFETY INSTRUCTIONS
1. Do not stand on seat.
2. Chair must e on level surface to ensure proper sta ility.
3. Only use chair when fully assem led.
4. Periodically check fasteners and tighten securely if
needed.
5. Never use chair if it does not perform according to this
manual.
MAINTENANCE
Pneumatic lift in lift assem ly is permanently lu ricated at
factory and needs no further lu rication. Never lu ricate
pneumatic lift.
Do not remove clip from ottom of lift assem ly. Contact
1-800-733-4000 immediately if clip is missing or damaged.
XL Series
High ack task chair
AAP-CP110