Alex SUPER ART TABLE 711W User manual

1 Table top
2 Paper roll holders 2 Plastic stars 1 Dowel
12 Bench
washers
4 Table
washers
4 Flat tipped screws
2 Bench tops 12 Bench legs 4 Table legs
TOOLS: Phillips head screwdriver required.
©2008 ALEX: Northvale, NJ 07647 Visit our website at www.alextoys.com
#711W
Adult assembly required
Preparing the chalkboard surface:
You will need a piece of chalk and paper towel.
First, holding the piece of chalk horizontally, rub
the chalk over the entire chalkboard surface.
Next, take the paper towel and, using a circular
motion, rub the towel over the chalkboard
surface. Finally, erase the chalk off the entire
surface. You have just seasoned your chalkboard
and it is ready for use.
WARNING: SMALL PARTS
CHOKING HAZARD -
Not for children under 3yrs.
Caution: Keep screws, small parts and plastic bags out of children's
reach during and after assembly

To Assemble the Table and Benches:
1
2
Using the four flat tipped
screws screw the paper roll
holders in place under the
table. DO NOT OVER
TIGHTEN!
Slide the rubber washers
over the threaded metal
rods on the ends of the legs.
Screw the legs on to the
table and benches as
shown, using the twelve
smaller legs for the
benches and the
four larger legs for
the table.
©2008 ALEX: Northvale, NJ 07647 Visit our website at www.alextoys.com
#711W

3
Slide the dowel through the
paper roll holder and a 12 -18"
paper roll. Secure it in place
with a threaded ball on either
end.
4
Pull the loose end of the paper
roll up through the slot in the
desk and thread it under the
paper cutter bar.
©2008 ALEX: Northvale, NJ 07647 Visit our website at www.alextoys.com
#711W