Alfa Romeo Stelvio User manual

Cop Stelvio Sup_Quadrif IT.indd 1 30/08/17 15:37

QUADRIFOGLIO
1
SEATS
MANUALLY ADJUSTABLE FRONT SEATS
1)
1)
"Sparco" Carbonshell Sport seats
(where provided)
Longitudinal adjustment
Lift lever 1 fig. 1 and push the seat
forwards or backwards.
IMPORTANT Make the adjustment while
sitting on the seat involved (driver side or
passenger side).
2)
fig. 1
Height adjustment (electrical)
Move button 2 upwards or downwards to
obtain the required height.
Backrest angle adjustment
Pull lever 3 fig. 1 and accompany the
backrest with the movement of your
torso (operate the lever until the desired
position is reached, then release it).
ELECTRICALLY ADJUSTABLE
FRONT SEATS
2)
fig. 2
This Supplement integrates the Alfa Stelvio Owner Handbook to which it is attached, and contains information on the Quadrifoglio
version. For anything not included, refer to the Owner Handbook.
Height adjustment
Use the rear part of switch 1, fig. 2, to
change the height and/or angle of the
seat cushion.
Longitudinal adjustment
Push switch 1, fig. 2, forwards or
backwards to move the seat in the
corresponding direction.
Backrest angle adjustment
Push switch 2, fig. 2, forwards or
backwards to tilt the backrest in the
corresponding direction.
Electric lumbar adjustment
Use joystick 3, fig. 2, to operate the
lumbar support device for maximum
driving comfort.
Operating the following parts of the
joystick:
❒top: inflates the cushion;
❒bottom: deflates the cushion;
❒front: inflates the top of the cushion;
❒back: inflates the bottom of
the cushion.
603.93.481 Alfa Stelvio 949 Quadrif 4ed GB.indd 1 15/03/18 11:51

2
WARNING
1) All adjustments must be made with the car
stationary.
2) After releasing the adjustment lever,
always check that the seat is locked on the
guides by trying to move it back and forth.
If the seat is not locked into place, it may
unexpectedly slide and cause the driver to
lose control of the car.
3) Always make sure that all occupants
are seated and wearing their seat belts
correctly.
IMPORTANT
1) The fabric seat upholstery has been
designed to withstand long-term wear due
to normal use of the car. Some precautions
are however required. Avoid prolonged
and/or excessive rubbing against clothing
accessories such as metal buckles andVelcro
strips which, by applying a high pressure on
the fabric in a small area, could cause it to
break, thereby damaging the upholstery.
2) Do not place any kind of object under the
electrically adjusted seats as it could impede
their movement or otherwise damage the
drives.
IMPORTANT Electrical adjustment is only
allowed when the ignition device is turned
to ON and for about 60 seconds after it is
turned to STOP. It is also possible to move
the seat for about
60 seconds after opening/closing the
door, locking/unlocking the vehicle or
switching the front central courtesy
light on.
Seat inclination adjustment (tilting)
(where provided)
The seat cushion angle can be set to
four positions. Lift or lower the front
of control 1, fig. 2, to move the front of
the seat in the corresponding direction.
Release control 1 when the seat has
reached the desired position.
Backrest width adjustment
(where provided)
Press the switches 4, fig. 2, to adjust the
backrest width by means of the lateral
padding.
Seat cushion extension
(where provided)
Lift the lever 6, fig. 3, and push the front
of the cushion forward or back. It can
move a few centimetres.
fig. 3
REAR SEATS
3)
The rear seats, fig. 2, allow three
passengers.
fig. 4
603.93.481 Alfa Stelvio 949 Quadrif 4ed GB.indd 2 15/03/18 11:51

3
QUADRIFOGLIO
DASHBOARD AND INSTRUMENT PANEL
TFT DISPLAY
fig. 5
1. Rev counter – 2. Digital engine oil temperature gauge with overheating warning light – 3. TFT Display
4. Digital fuel level gauge (the triangle on the left side of the symbol indicates the side of the car with the fuel filler) – 5. Speedometer
Apart from the instrument panel display size, there may be small differences according to the version or the end market destination
of the car.
603.93.481 Alfa Stelvio 949 Quadrif 4ed GB.indd 3 15/03/18 11:51

4
SBA (Seat Belt Alert) SYSTEM
REAR SEAT BELT ICON BEHAVIOUR
(where provided)
The icons are shown on the display
(fig. 6) after a few seconds have elapsed
since the ignition device is turned to ON
and disappear after approximately 30
seconds.
After a door closes, or following a change
in belt fastening status, the icons are
shown again for approximately 30
seconds before disappearing.
The icons shown on the display indicate:
1. rear left seat belt;
2. rear central seat belt.
3. rear right seat belt.
fig. 6
Wear the rear seat belts as shown in fig. 7
and fig. 8.
fig. 7
fig. 8
“Alfa DNA™ Pro” SYSTEM
“Alfa DNA™ Pro” SYSTEM
(dynamic car control system)
Using the selector (on the central tunnel),
fig. 9, this device selects different car
response modes according to driving
style and road conditions:
fig. 9
Ud = Dynamic (sports driving mode)
Un = Normal (mode for driving in normal
conditions)
Ua = Advanced Efficiency (ECO driving
mode for maximum fuel savings).
URACE = track race driving mode.
U= changes the suspension setting
(where provided).
Unlike the other ones, the RACE position
is unstable, therefore, by rotating the
selector to RACE, it will return to its initial
position "d".
603.93.481 Alfa Stelvio 949 Quadrif 4ed GB.indd 4 15/03/18 11:51

5
QUADRIFOGLIO
The RACE symbol lights up in red on the
selector when this mode is active.
The different modes are characterised by
different colours on the instrument panel
display:
UNormal - Blue,
UDynamic - Red
URACE - Yellow
UAdvanced Efficiency - Green
“RACE” MODE
Engagement/disengagement
It is activated by rotating the selector to
position "RACE", the displays light up in
yellow.
IMPORTANT This mode should be
activated on race tracks.
To deactivate the RACE mode, take the
selector to position "RACE" again and the
system will be set to "d" mode.
ALFA ACTIVE
SUSPENSION (AAS)
The electronic suspensions control
system of the car is the result of a
sophisticated elaboration of the various
board sensors, aimed at optimising the
performance of the car.
The system continuously monitors the
damping of the suspensions through
the actuator installed on each shock
absorber. This way, the calibration of the
shock absorbers can be adjusted to the
conditions of the road surface and to
the dynamic conditions of the vehicle,
improving its comfort and road holding.
The driver can choose, even while driving
(only in "d" or "RACE" mode), between
two types of suspension setting: a more
sporty or a more comfortable one.
By pressing the button, the system
prepares to work with a shock absorber
calibration which favours driving comfort.
fig. 10
In the event of a system failure, the
symbol appears on the instrument
panel display together with a dedicated
message.
603.93.481 Alfa Stelvio 949 Quadrif 4ed GB.indd 5 15/03/18 11:51

6
EMERGENCY STARTING
REMOTE BATTERY CONNECTION POLES
To facilitate the operation, the remote
poles of the battery for the jump starting
can be found in the engine compartment:
the battery, on the other hand, is placed in
the luggage compartment.
The negative terminal (–) fig. 11 is
positioned next to the right bonnet lock.
fig. 11
The positive terminal (+), shown in fig. 13,
can be reached by lifting the protective
flap, fig. 12.
fig. 12
fig. 13
To carry out the operation, you need to
have the correct cables to connect the
auxiliary battery to the remote poles of
the flat battery.
Usually, these cables have terminals at
the ends and are identified by different
sheath colours (red = positive,
black = negative).
603.93.481 Alfa Stelvio 949 Quadrif 4ed GB.indd 6 15/03/18 11:51

7
QUADRIFOGLIO
SCHEDULED SERVICING PROGRAMME (2.9 V6 engine)
The checks listed in the Scheduled Servicing Plan, after reaching 150,000 km/10 years, must be cyclically repeated starting from
the first interval, thus following the same intervals as before.
Thousands of miles 9 18 27 36 45 54 63 72 81 90
Thousands of kilometres 15 30 45 60 75 90 105 120 135 150
Years 1 2 3 45678910
Check battery charge status with the proper instrument ••••••••••
Check tyre condition/wear and adjust pressure, if necessary.
Check quick tyre repair kit recharge conditions/expiry date
(where provided) ••••••••••
Check operation of lighting system (headlights, direction
indicators, hazard warning lights, boot, passenger
compartment, glove compartment, instrument panel
warning lights, etc.)
••••••••••
Check and, if necessary, top up fluid levels (1) ••••••••••
Check exhaust emissions ••••••••••
Check the supply/engine control and emissions systems
operation using the diagnosis equipment ••••••••••
Visually inspect condition of: exterior bodywork, underbody
protection, pipes and hoses (exhaust, fuel system, brakes),
rubber elements (gaiters, sleeves, bushes, etc. ) •••••
Check windscreen and rear window wiper blade position/wear •••••
(1) Only use the fluids shown in the handbook for topping up, and only after checking that the system is intact.
603.93.481 Alfa Stelvio 949 Quadrif 4ed GB.indd 7 15/03/18 11:51

8
Thousands of miles 9 18 27 36 45 54 63 72 81 90
Thousands of kilometres 15 30 45 60 75 90 105 120 135 150
Years 1 2 345678910
Check operation of the windscreen wiper/washer system and
adjust jets, if necessary •••••
Check cleanliness of bonnet and luggage compartment locks,
cleanliness and lubrication of linkage •••••
Visually inspect conditions and wear of front disc brake pads
and operation of pad wear indicators ••••••••••
Visually inspect conditions and wear of rear disc brake pads
and operation of pad wear indicators ••••••••••
Visually inspect the condition and tensioning of the accessory
drive belt(s) ••• ••• ••
Change engine oil and replace oil filter ••••••••••
Change the Transfer Case oil (for AWD versions) •
Spark plug replacement ••
Replace accessory drive belt/s (2)
Replace air cleaner cartridge (3) •••••
Change the brake fluid (4)
Replace the passenger compartment filter (3) o•o•o•o•o•
(2) Areas that are not dusty: recommended maximum distance 60,000km. Regardless of the mileage, the belt must be replaced
every 4 years. Dusty areas and/or heavy conditions (cold climates, urban driving, long periods of idling): the recommended maximum
distance is 30,000km. The belt must be replaced every 2 years, regardless of distance travelled.
(3) If the vehicle is used in dusty areas, the filter must be replaced every 15,000 km.
(4) The brake fluid must be changed every two years, regardless of the mileage.
(o) Recommended operations
(•) Mandatory operations
603.93.481 Alfa Stelvio 949 Quadrif 4ed GB.indd 8 15/03/18 11:51