www.rockwellautomation.com
Amer
i
cas:
Rockwell
Automation, 1201 South
Second
Street,
Milwaukee,
WI 53204
-
2496
USA,
Tel:
(1)
414.382.2000, Fax: (1)
414.382.4444
Europe
/
Middle East
/
Africa:
Rockwell
Automati
on,
Pegasus
Park,
De Kleetlaan 12a,
1831 Diegem, Belgium,
Tel: (32) 2 663
0600, Fax: (32) 2 663
0640
Asia Pacific: Rockwell Automation, Level 14,
Core F,
Cyberport
3, 100
Cyberport Road,
Hong Kong,
Tel: (852) 2887 4788, Fax:
(852) 2508
1846
Power,
Control
and
Information Solutions
Headquarters
U.S.
Allen-Bradley
Drives
T
echnical
Support
-
T
el:
(1)
262.51
2.8176, Fax: (1) 262.512.2222, E-mail: [email protected]a.rockwell.com, Online: www.ab.com/support/abdrives
Publication 750-IN002F-MU-P – April 2015
Supersedes 750-IN002E-MU-P – July 2013 Copyright © 2015 Rockwell Automation, Inc. All rights reserved. Printed in USA.
Auxiliary Power Supply (20-750-APS) Installation
A connector cable is provided with Auxiliary Power Supply option module for use in PowerFlex 753 Drives and in
PowerFlex 755 Frame 1 drives. The cable is used to connect the module to the backplane when installed on the upper
control pod brackets.
IMPORTANT: Do not use the Auxiliary Power Supply option module with Frame 8 and larger drives. Refer to the
PowerFlex 750-Series AC Drives Installation Instructions, publication 750-IN001 for information on connecting an
external power supply to Frame 8 and larger drives.
Option Module Installation next to a Profibus Option Module
If a PowerFlex 20-750-PBUS Profibus option module resides in the adjacent port
to the right of the port in which the new module is being installed, the lower T15
Torx™ head mounting screw (see Detail A) of the new module may electrically
contact the metal Profibus cable connector attached to the Profibus option
module. This may cause faulty operation. To help prevent this, perform the steps
below. If a PowerFlex 20-750-PBUS Profibus option module is not in that port,
disregard these steps.
1. Remove the lower T15 Torx head mounting screw shown in Detail A,
from the new module being installed.
To remove the captive T15 Torx head screw, the module must be removed
to back the screw out of the mounting clip.
2. Replace the larger T15 Torx head screw with the smaller spare T8 Torx
head mounting screw that was shipped with the PowerFlex 20-750-PBUS
Profibus option module.
Detail A
Profibus Option
Module
