Allied Telesis AT-AR2010V User manual

613-002264 Rev A
AT-AR2010V
Installation Guide
AR2010V
12
ETH
CONSOLE
1000 LINK
ACT
100 LINK
ACT
FDX
HDX
COL
FAULT
PWR
FNC1
FNC2
READY
FAULT
RESET
DC 12-24V

Copyright 2015 Allied Telesis, Inc.
All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Telesis, Inc.
Allied Telesis and the Allied Telesis logo are trademarks of Allied Telesis, Incorporated. All other product names, company names,
logos or other designations mentioned herein are trademarks or registered trademarks of their respective owners.
Allied Telesis, Inc. reserves the right to make changes in specifications and other information contained in this document without prior
written notice. The information provided herein is subject to change without notice. In no event shall Allied Telesis, Inc. be liable for
any incidental, special, indirect, or consequential damages whatsoever, including but not limited to lost profits, arising out of or related
to this manual or the information contained herein, even if Allied Telesis, Inc. has been advised of, known, or should have known, the
possibility of such damages.

3
Electrical Safety and Emissions Standards
This product meets the following standards.
EMC: Not available at present
Electrical Safety: Not available at present
Environmental Compliance: Not available at present
U.S. Federal Communications Commission
Radiated Energy
Note: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15
of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with this instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Note: Modifications or changes not expressly approved of by the manufacturer or the FCC, can void your right to operate
this equipment.
Industry Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Warning: In a domestic environment this product may cause radio interference in which case
the user may be required to take adequate measures.

4
Translated Safety Statements
Important: Safety statements that have the symbol are translated into multiple languages in the
Translated Safety Statements document at www.alliedtelesis.com/support.

5
Preface ..............................................................................................................................................................................11
Document Conventions ..............................................................................................................................................12
Contacting Allied Telesis ............................................................................................................................................13
Chapter 1: Overview .........................................................................................................................................................15
Features .....................................................................................................................................................................16
ETH Ports ............................................................................................................................................................16
USB Port .............................................................................................................................................................16
USB Retainer Slot ...............................................................................................................................................16
Reset Button ........................................................................................................................................................16
LEDs ....................................................................................................................................................................16
DC Power Inlet ....................................................................................................................................................16
Kensington Lock Hole .........................................................................................................................................17
Installation Options ..............................................................................................................................................17
Management Software and Interfaces ................................................................................................................17
Management Methods .........................................................................................................................................17
Package Contents ......................................................................................................................................................18
Front and Back Panels ...............................................................................................................................................19
Management Panel ....................................................................................................................................................20
Management Software ...............................................................................................................................................21
ETH Ports ...................................................................................................................................................................22
LEDs ...........................................................................................................................................................................23
Power LED ..........................................................................................................................................................23
Fault LED ............................................................................................................................................................24
USB LED .............................................................................................................................................................24
ETH1 Port LEDs ..................................................................................................................................................25
............................................................................................................................................................................26
ETH2 Port LEDs ..................................................................................................................................................27
Function 1 LED ....................................................................................................................................................28
Function 2 LED ....................................................................................................................................................28
USB Port .....................................................................................................................................................................29
DC Power Inlet ...........................................................................................................................................................30
USB Retainer Slot ......................................................................................................................................................31
Console Port ...............................................................................................................................................................34
Reset Button ...............................................................................................................................................................35
Power Supply .............................................................................................................................................................36
Chapter 2: Beginning the Installation .............................................................................................................................37
Reviewing Safety Precautions ....................................................................................................................................38
Choosing a Site for the Routers .................................................................................................................................41
Unpacking the Router .................................................................................................................................................42
Chapter 3: Installing the Router and Powering on the Router .....................................................................................43
Installing the Router on a Table or Desktop ...............................................................................................................44
Chapter 4: Cabling the Networking Ports .......................................................................................................................53
Cabling the Twisted Pair Ports ...................................................................................................................................54
Chapter 5: Troubleshooting .............................................................................................................................................57
Appendix A: Technical Specifications ...........................................................................................................................59
Contents

Contents
6
Physical Specifications................................................................................................................................................59
Environmental Specifications.......................................................................................................................................59
Power Specifications ...................................................................................................................................................61
Certifications................................................................................................................................................................61
RJ-45 Twisted Pair Port Pinouts..................................................................................................................................62
RJ-45 Style Serial Console Port Pinouts.....................................................................................................................63
Front DC Power Connector .........................................................................................................................................63

7
Figure 1: Front panel of the AT-AR2010V router..................................................................................................................19
Figure 2: Back panel of the AT-AR2010V router..................................................................................................................19
Figure 3: AT-AR2010V management panel..........................................................................................................................20
Figure 4: ETH ports ..............................................................................................................................................................22
Figure 5: Power LED ............................................................................................................................................................23
Figure 6: Fault LED...............................................................................................................................................................24
Figure 7: USB LED...............................................................................................................................................................25
Figure 8: ETH1 Port LEDs....................................................................................................................................................25
Figure 9: ETH2 Port LEDs....................................................................................................................................................27
Figure 10: Function 1 LED....................................................................................................................................................28
Figure 11: Function 2 LED....................................................................................................................................................28
Figure 12: USB port..............................................................................................................................................................29
Figure 13: DC Power Inlet ....................................................................................................................................................30
Figure 14: USB retainer slot .................................................................................................................................................31
Figure 15: USB retainer........................................................................................................................................................32
Figure 16: Attaching the USB retainer..................................................................................................................................32
Figure 17: Attaching the cable tie.........................................................................................................................................33
Figure 18: Console port........................................................................................................................................................34
Figure 19: Reset button........................................................................................................................................................35
Figure 20: Components of the AT-AR2010V router..............................................................................................................42
Figure 21: Attaching the rubber feet.....................................................................................................................................45
Figure 22: Orienting the mounting kit....................................................................................................................................47
Figure 23: Securing the mounting kit....................................................................................................................................47
Figure 24: Rotating the router down to snap it into place.....................................................................................................48
Figure 25: Connecting the Management Cable to the Console Port....................................................................................50
Figure 26: Router initialization messages.............................................................................................................................51
Figure 27: Router initialization messages (Continued).........................................................................................................52
Figure 28: RJ-45 Socket Pin Layout (Front View) ................................................................................................................62
Figure 29: Front DC Power Connector.................................................................................................................................63
Figures

Figures
8

9
Tables
Table 1: Power LED .............................................................................................................................................................23
Table 2: Fault LED ...............................................................................................................................................................24
Table 3: USB LED ...............................................................................................................................................................25
Table 4: LEDs for ETH1 Port ...............................................................................................................................................26
Table 5: LEDs for ETH2 Port ...............................................................................................................................................27
Table 6: Product Dimension ................................................................................................................................................59
Table 7: Product Weight ......................................................................................................................................................59
Table 8: Environmental Specifications .................................................................................................................................59
Table 9: Maximum Power Consumption ..............................................................................................................................61
Table 10: Input Voltages ......................................................................................................................................................61
Table 11: Product Certifications ...........................................................................................................................................61
Table 12: Pin Signals for 10 and 100 Mbps .........................................................................................................................62
Table 13: Pin Signals for 1000 Mbps ...................................................................................................................................62
Table 14: RJ-45 Style Serial Console Port Pin Signals .......................................................................................................63
Table 15: Front DC Power Connector Pin Signals ..............................................................................................................64

Tables
10

11
Preface
This guide contains the installation instructions for the AT-AR2010V router.
This preface contains the following sections:
“Document Conventions” on page 12
“Contacting Allied Telesis” on page 13

Preface
12
Document Conventions
This document uses the following conventions:
Note
Notes provide additional information.
Caution
Cautions inform you that performing or omitting a specific action
may result in equipment damage or loss of data.
Warning
Warnings inform you that performing or omitting a specific action
may result in bodily injury.

Installation Guide for AT-AR2010V Router
13
Contacting Allied Telesis
If you need assistance with this product, you may contact Allied Telesis
technical support by going to the Support & Services section of the Allied
Telesis web site at www.alliedtelesis.com/support. You can find links for
the following services on this page:
24/7 Online Support — Enter our interactive support center to
search for answers to your product questions in our knowledge
database, to check support tickets, to learn about RMAs, and to
contact Allied Telesis technical experts.
USA and EMEA phone support — Select the phone number that
best fits your location and customer type.
Hardware warranty information — Learn about Allied Telesis
warranties and register your product online.
Replacement Services — Submit a Return Merchandise
Authorization (RMA) request via our interactive support center.
Documentation — View the most recent installation and user
guides, software release notes, white papers, and data sheets for
your products.
Software Downloads — Download the latest software releases for
your managed products.
For sales or corporate information, go to www.alliedtelesis.com/
purchase and select your region.

Preface
14

15
Chapter 1
Overview
This chapter contains the following sections:
“Features” on page 16
“Package Contents” on page 18
“Front and Back Panels” on page 19
“Management Panel” on page 20
“Management Software” on page 21
“ETH Ports” on page 16
“LEDs” on page 23
“USB Port” on page 29
“DC Power Inlet” on page 30
“USB Retainer Slot” on page 31
“Console Port” on page 34
“Reset Button” on page 35
“Power Supply” on page 36

Chapter 1: Overview
16
Features
Here are the features of the AT-AR2010V router.
ETH Ports Here are the basic features of the ETH ports.
Two copper ETH ports for WAN connection
10Base-T (IEEE 802.3i), 100Base-TX (IEEE 802.3u), and
1000Base-T (IEEE 802.3ab) compliant
IEEE 802.3u Auto-Negotiation compliant
Auto-MDI/MDIX
100 meters (328 feet) maximum operating distance
RJ-45 connectors
USB Port Here is the basic feature of the USB port.
Used for maintenance
USB Retainer
Slot Here are the basic features of the USB retainer slot.
Used in conjunction with the USB retainer kit
Used for preventing the USB device from falling out of the router
Reset Button Here are the basic features of the reset button.
Returns to factory default settings
Reboots the router
LEDs Here are the LEDs.
One Power LED
One Fault LED
One USB LED
One Duplex/collision LED and one link/activity LED for the ETH 1
port
One Duplex/collision LED and one link/activity LED for the ETH 2
port
One Function 1 LED
One Function 2 LED
DC Power Inlet Here are the basic features of the DC power inlet.
One DC power inlet on the front panel

Installation Guide for AT-AR2010V Router
17
Supports external DC power supply
One AC Adapter connector on the back panel for external AC
power supply
Kensington Lock
Hole Here are the basic features of the Kensington lock hole.
Used for attaching a lock-and-cable apparatus
One hole located on the center of the back panel
Installation
Options Here are the installation options for the routers.
Desk or tabletop
DIN rail mounting
Management
Software and
Interfaces
Here are the management software and interfaces.
AlliedWare Plus™ Operating System
Command line interface
Management
Methods Here are the methods for managing the routers.
Local management through the Console port
Remote Telnet and Secure Shell management
SNMPv1, v2c, and v3

Chapter 1: Overview
18
Package Contents
1 main unit
1 AC Adapter and regional power cord
1 addendum document sheet
1 USB retainer
1 double-side adhesive tape
2 cable ties
4 stick-on rubber feet kit
1 RS-232 console cable
1 3-Pin DC plug to go with the DC input socket on the front panel

Installation Guide for AT-AR2010V Router
19
Front and Back Panels
The front panel of the AT-AR2010V router is shown in Figure 1.
Figure 1. Front panel of the AT-AR2010V router
The back panel of the AT-AR2010V router is shown in Figure 2.
Figure 2. Back panel of the AT-AR2010V router
AR2010V
12
ETH
CONSOLE
1000 LINK
ACT
100 LINK
ACT
FDX
HDX
COL
FAULT
PWR
FNC1
FNC2
READY
FAULT
RESET
DC 12-24V
12VDC
1.5A MAX

Chapter 1: Overview
20
Management Panel
Figure 3 identifies the components in the management panel on the AT-
AR2010V router.
Figure 3. AT-AR2010V management panel
CONSOLE
1000 LINK
ACT
100 LINK
ACT
FDX
HDX
COL
FAULT
PWR
FNC1
FNC2
READY
FAULT
RESET
DC 12-24V
Console Port USB Port
Reset Button