2
Attaching the STND-J03 Bracket to a Device
1. Review safety precautions for the device you are
installing.
2. Attach the two rubber feet to each stand bracket.
3. Orient the stand brackets at the bottom of the
device and tighten the screws.
4. Turn the device and place the brackets on the flat
surface.
5. Connect necessary cables to the ports of the
device.
6. Secure the cables using the hook-and-loop
fastener.
Physical Specifications
Copyright 2022 Allied Telesis, Inc.
All rights reserved.
No part of this publication may be reproduced without prior
written permission from Allied Telesis, Inc.
Allied Telesis and the Allied Telesis logo are trademarks of Allied
Telesis, Incorporated. All other product names, company names,
logos or other designations mentioned herein are trademarks or
registered trademarks of their respective owners.
Allied Telesis, Inc. reserves the right to make changes in
specifications and other information contained in this document
without prior written notice. The information provided herein is
subject to change without notice. In no event shall Allied Telesis,
Inc. be liable for any incidental, special, indirect, or
consequential damages whatsoever, including but not limited to
lost profits, arising out of or related to this manual or the
information contained herein, even if Allied Telesis, Inc. has
been advised of, known, or should have known, the possibility of
such damages.
Item Dimensions (W x D x H) Weight
Stand
Bracket
120 mm x 45 mm x 2 mm
(4.7 in. x 1.8 in. x 0.1 in.)
75 g
(0.17 lbs)
Hook & loop
Fastener
19 mm (W) x 152 mm (L)
(0.7 in. x 6 in.)
N/A
613-003082 Rev. B
