Alphatech Blue Gate ISDN BRI Brave User manual

Install BlueGate ISDN Brave Configuration software on your PC. Please, follow instructions in Installation.pdf.
Mode?
Does SIM card have
PIN code?
Quick Start of Blue gate ISDN Brave
Set switches for terminal rezistors
Open the bo and set switches for terminal rezistors.
There are 4 switches for connecting 100 Ohm terminal rezistors. Switches 1, 2 are used
for TE mode, switches 3, 4 are used for NT mode.
efault setting is TE - off, NT – on
(Synchro mode).
Router
Synchro
No
Yes
Start
TE mode
Find out IN code (at various mobile phone ) and remember it.
When you run Configuration SW you can type it in configuration data.

Insert SIM card
By pressing of yellow button release the SIM card holder.
Insert the SIM card and replace the SIM card holder.
Insert antenna
The available place for installation select up following point of view:
1. Distance from PBX lines – possibility of GSM interferences
2. Main 230 V for power supply of BlueGate ISDN Brave
3. Quality of GSM signal at the installation place
Connect device to main 230V
INPUT : 100-240V 0.7A 50/60Hz
OUTPUT : 5V 3A
DC Plug Dimension : 5.5mm 2.5mm.
Correctly connect USB cable
and ISDN lines
Set initial parameters of Bluegate ISDN Brave Configuration SW on the PC
to work device correctly.
Start Bluegate ISDN Brave Configuration
Clic on New File

Select the mode that you want to use
Suppose you set the correct switches
for connecting 100 Ohm terminal resistors
If you want to use network connection
set all parameters.
Blue Gate Brave1
You can assign the name
of your equipment
Choose the proper ial tone
·
Set parameters for TE mode
In case of Synchro mode no need to ad ust
anything,no matter
Set at least the following parameters:
Set parameters for NT mode according
to the connected PBX.

1234
In case of Synchro mode or
Router mode select A-NT
In case of ISDN mode TE
select output line B-TE
If you use DISA (Direct Inward System Access)
set time ≠ 0 and also set the min. and maximum length
of DTMF digits
Type PIN code if there is one
Include the GSM modules GSM1 and GSM2 to
the appropriate groups.
Enter the number where
incoming calls are directed.
All calls are routed to the e tension
entered in this table (in order),
if the parameter Waiting for DISA
is 0 or number of called digits is less
then Minimal e tension length.
Ma . count of this e tension is 5.

All calls from Input line A-NT
will be routed to GSM network (Outgoing Group 1)
Save this items into Routing profile.
IIn case of Synchro mode or Router mode select A-NT
In case of IS N mode TE select output line B-TE.
Type length of digits, which will be sent.
0' means that length of called number is unknown and end of dial is
recognized after timeout defined in Wait for dialing. This parameter can
make the call arrangement faster.
In router mode if any item is not in Routing table
all calls are routed from the PBX to the PSTN
and vice versa.
You can A the routing item.
One line will be added into routing table.
You can E IT default routing profile and set all routing items

After 40 seconds =the Led of GSM
starts fast blinking. Then if GSM is
registered and full service, the Led is
blinking slow.
In another case see in Bluegate ISDN Brave
Configuration in Diagnostics ->GSM Modules
Status what is the matter.
Try to call
Now it is time to save your setting into device.