alpro EL900 User manual

ANSI Electric Strike
EL900 - Instructions
alpro®
M5
x 2 Screws
155
124.6
105
86.4
17.2
25
Fail Safe - (PTL)
Screw Fitted in park
hole
Fail Secure - (PTO)
Screw Fitted
TECHNICAL INFORMATION
Power consumption and current
draw
12v DC - 300mA
24v DC - 150mA
Wiring Monitoring
The EL900 can be used in either
fail safe (PTL) or fail secure (PTO)
mode. Simply ensure that the screw
is positioned in either hole as per
the illustration and either function
can be achieved. Retain screw for
future use (PTO).
General Installation Instructions
Check with a suitable meter that the
regulated power supply or controller
being used to operate the strike can
provide the required voltage within a
+/- 10% tolerance, and that the
voltage can be maintained during
operation under all circumstances.
Warning: Connection of an
incorrect voltage may result in
damage not covered by the
product warranty.
Mortice the door frame using the
actual body of the strike as the
template. Ensure that if the
mortice lock being used has a
deadlocking snib or trigger, the
location of the strike must not allow
the snib to enter the ‘keep’ area.
Blue
Green
Yellow
Red
12V DC
Red
+
--
NC
C
NO
First Choice for Locking Solutions
01202 676262 01202 680101 [email protected] www.iecltd.co.uk
T F E W
1
2
EL900 Instructions 28/2/06 3:01 pm Page 1

International Engineering Company Ltd Harwell Rd Nuffield Est., Poole BH17 0BD Great Britain
The Distributor with the difference
Registered in England 1925337
© February 2006 IEC. All rights reserved.
All dimensions are nominal and subject to tolerances RS 00117
ANSI Electric Strike
EL900 - Instructions
01202 676262 01202 680101 [email protected] www.iecltd.co.uk
T F E W
44.7
66
80.3 86.6
185.5
15.9
25
28.5
16.5
6.0
201
3
124
105.2
86.6 80.3
66
44.7
28.5
23.5
31.7
16.5
2 Ø 5.2
2 Ø 4.3
3
31.7
Position the strike into the mortice
and drill the two fixing holes. A set of
fixings are supplied for both timber
and metal fixing.
Ensure that all wiring is correctly
terminated and not snagged within
the mortice. Install the strike back
into the mortice temporarily in this
correct position and check that there
is no mechanical interference
between the door, the lock faceplate
and the strike face and extension lip
(if fitted) during the closing cycle.
Check that no side load pressure is
being exerted on the strike when the
door is closed.
When all the above 5 points have
been checked and are completed,
secure the strike using the correct
fixings and re-check operation.
Warranty
This product is guaranteed for a period
of 1 year against defects in
manufacture, workmanship or materials
provided that all electrical and
mechanical installation requirements are
adhered to as per this instruction sheet.
All third party and consequential claims
are expressly excluded from this
warranty.
6
5
4
3
alpro®
Short/Long SS face plate
options and 25mm
Extension Lip included in
Strike Kit
EL900 Instructions 28/2/06 3:01 pm Page 2