Altec AIR User manual

100520095-B
ALTEC AIR FLOOR STAND ASSEMBLY
INSTRUCTIONS
Step 1: Identify the components of the Altec Floor Stand:
Diagrams are located on the last pages of this instruction guide. All floor stands
are made with the same design, custom to the size of the Refrigerated Air Dryer.
Step 2: It is easiest to assembly the Floor Stand upside down with the top panel
face down on the ground and the flanges facing up.
Step 3. Secure one side panel to the top panel using the supplied hardware and
holes provided. Repeat with the second side panel.

100520095-B
Step 4. Attach braces to the outside of the side panels using supplied hardware
and holes provided.
Step 5. Tighten all screws using 7/16” wrenches.
Step 6. Carefully turn the Floor Stand right side up and place into desired location.
Anchor holes have been provided on the bottom of the legs for optional but
recommended anchoring of Floor Stand to the floor.
Step 7. Mount your Altec AIR Refrigerated Air Dryer to the Floor Stand using
supplied hardware.
Note: If you own a RAD-0025, RAD-0040, or RAD-0055 unscrew the rubber feet
currently mounted to the bottom of the unit. The threaded holes used for the
feet are what are to be used to mount the unit to the floor stand.

100520095-B

100520095-B

100520095-B

100520095-B