ALZA STORMRED PRO User manual

1
STORMRED PRO
TRAMPOLINE USER MANUAL

2
English
3 – 19
Čeština
20 – 36
Slovenčina
37 – 53
Magyar
54 – 70

3
IMPORTANT INFORMATION
- WARNING!ADULT SUPERVISION & GUIDANCE REQUIRED ATALL TIMES.
- Recommended age 6+ years.
- No somersaults or flips - will cause serious injury.
WARNINGS!
Max user weight limit:
8FT, 10FT 120KG
12FT,14FT,15FT,16FT 150KG
Not suitable for children under 36 months - small parts, chokinghazard.
The trampoline is intended for outdoor use only.
Only one user at a time. Danger of Collision hazard.
Always close the net opening before jumping.
Jump without shoes.
Do not use the mat when it is wet
Empty pockets and hands before jumping
Always jump in the middle of the mat
Do not eat while jumping. It is advisable not to bounce immediately after ameal.
Do not exit by a jump
Do not use in strong wind conditions and secure thetrampoline.
The trampoline shall be assembled by an adult in accordance with the assembly instructions and thereafter checked
before the first use.
Limit the time of continuous usage (make regularstops).
ADVISORY
This trampoline is not intended to be buried in the ground.
The trampoline must be placed on a level surface at least 2m from any structures or obstructions such as fence,
garage, house, overhanging branches, laundry lines or electricalwires.
Do not install the trampoline over concrete, asphalt or any other hard surface. Also not in proximity ofother
conflicting installations, such as padding / swimming pools, swings, slides or climbingframes.
Any modifications made by the consumer to the original trampoline (e.g. the adding of an accessory) shall be carried
out according to the instructions of themanufacturer.
Inspect trampoline / enclosure net before eachuse.
If an access ladder is used it should be removed when trampoline is not inuse.
Make sure there are no children / animals / obstructions underneath thetrampoline.
Access the trampoline through the door of the enclosure net only. Making sure you securely close it before bouncing.
Use: Ensure the door is securely closed beforebouncing.
Don’t intentionally rebound off the enclosure net as this will weaken it.
Only attach manufacturer approved accessories to the trampoline and enclosurenet.
Always jump in the middle of the mat and practice bounce techniques safely with adult supervision and
guidance.

4
ASSEMBLY AND MAINTENANCE INSTRUCTIONS
Attention to the need to carry out checks and maintenance of the main parts (frame, suspension system, mat, padding,
and enclosure) at the beginning of each season and also at regular intervals of every 2 weeks, pointing out that if these
checks are not carried out, the trampoline could becomedangerous.
Check all nuts and bolts for tightness and tighten when required.
Check that all spring-loaded (pit pin) joints are still intact and cannot become dislodged duringplay.
Check all coverings and sharp edges and replace when required.
Retain the maintenance instruction manual.
Outdoor trampolines should be equipped with a device that in strong wind conditions avoid displacement due to wind
(e.g. steel bars in the ground or loads like sand bag or water bags) and/or items catching wind like net and mat should be
removed.
In certain countries during winter period, the snow load and the very low temperature can damage the
trampoline. It is recommended to remove the snow and store the mat and the enclosureindoor.
Check that mat, padding, enclosure and soft surface are withoutdefects.
NOTE: Sunlight, rain, snow and extreme temperatures reduce the strength of these parts overtime.
Make sure that the hook-and-loop fasteners are closed correctly during use oftrampoline!
Trampoline and net should be packed away in winter. Make sure all parts are dry and packed securely. Store dry to
support product longevity. Always be aware of wear and tear due to weather andwind.
We recommend securing the trampoline in strong winds. Tie the trampoline down with ropes attached to the trampoline
pad. Tie the trampoline down in a minimum of three places distributed evenly across the trampoline frame.
Do not secure the legs as these may become misaligned and ruin the trampoline. Dismantle or remove the trampoline
completely, if required. It may result in great danger if the trampoline is not secured in strong winds.
If the trampoline is not used for short periods of time and to avoid jump mat debris caused by fallen leaves and twigs, It’s
recommended usage of a Weather Cover. When the trampoline is not used for a longer period of time (e.g. during the
winter). It’s recommended storing the trampoline, especially the protective padding, in a dry area to support product
longevity.

5
MOVING INSTRUCTIONS
PLEASE READ THESE ASSEMBLY GUIDELINES BEFORE STARTING TO ASSEMBLE THE TRAMPOLINE.
INCORRECT ASSEMBLY WILL CAUSE DAMAGE TO THE TRAMPOLINE FRAME.
Make sure the trampoline is placed on level ground. Uneven ground surfaces may cause the trampoline frame to warp.
Make sure that all bolts holding the frame joints are tightened completely before installing the springs. Failure to do this
properly will cause the frame to warp.
Make sure NOT to use one’s leg to push against the trampoline leg or frame when loading the springs. It will cause the
trampoline to warp.
DO NOT load the springs onto the frame on only one side of the trampoline. Uneven distribution of tension from the
springs will cause the frame to warp.
If the trampoline frame warps up, do not be alarmed as the “Quad-lock” system is designed to be flexible. Push down on
the part of the frame that warped with two people as shown. The frame will levelout.
Moving trampoline. If the trampoline and enclosure needs to be moved, it should be moved by two persons at least, kept
horizontal, and lifted slightly. If necessary, the trampoline and enclosure can be taken for moving. To take the trampoline
apart, follow the assembly steps in reverse order.
If you need to move the trampoline, two people should be used at least. All connector points should be wrapped secured
with weather resistant tape, such as duct tape. This will keep the frame intact during the move and prevent the connector
points from dislocating and separating. When moving, lift the trampoline slightly of the ground and keep it horizontal to
the ground. For any type of other move, you should disassemble the trampoline.

6
Fundamental Bounce
1. Start from a standing position with your head erect
and your eyes on the frame pad.
2. Swing your arms forward and up in a circular
motion.
3. Bring your feet together and point your toes
downward while in the air.
4. Keep your feet about 30 cm (15 in.) apart when
landing on the bed.
Knee Drop
1. Start bouncing from a standing position, keeping
your eyes on the frame pad.
2. Land on your knees, keeping your back straight
and your body erect.
3. Bounce back to an erect position.
Seat Drop
1. Land in a sitting position with your legs parallel to
the bed.
2. Place your hands on the bed beside yourhips.
3. Push with your hands to return to an erect
position.
Front Drop
1. Start from a low bounce and land on the bed in a
prone position.
2. Keep your head up and your arms extended
forward on the bed.
3. Push with your arms to return to an erectposition.
BASIC TRAMPOLINE SKILLS
A certified trampoline instructor should be contacted to further develop your trampoline skills.

7
Please read the assembly instructions before beginning to assemble the product.
Please refer to the table below for parts description and numbering.
Make sure you have all the parts listed. If you are missing any parts, please contact place of purchase.
Please use gloves to protect your hands from pinch points during assembly. When you are ready to start, make sure
that you have plenty of space and a clean dry area for assembly.
Trampoline Part List
Item
Photo Part 8FT 10FT 12FT 14FT 15FT 16FT
A Frame Cover 1 1 1 1 1 1
B Jumping Mat 1 1 1 1 1 1
C Top Rail 6 8 8 8 12 12
D T-connector 6 8 8 8 12 12
E Spring 48 64 72 96 108 108
F Leg
Extension
0 8 8 8 12 12
G W-Shaped
Leg
3 4 4 4 6 6
H Spring tool
T-hook
1 1 1 1 1 1
I Screw 0 8 8 8 12 12
J
Screwdriver 1 1 1 1 1 1
ATTENTION: 2 adults in good physical condition are required for the following assembly. Wear proper shoes and maintain
balance to prevent a fall. Failure to follow all instructions and warnings exactly may result in serious injury.

8
F
F
G
I
J
D
C
Step 1: Trampoline Frame Assembly
1. By attaching two Leg Extension (F) to W-shaped Legs(G), to form a “U” shaped with Screws (I) by Screwdriver (J).
Repeat this step with the remaining pieces to make the rest U legs. Leave to one side when finished.
2. Begin by attaching Top Rails (C) to T-connectors (D). Continue until you form a largecircle.
Tip: Have a second person or use a wall to apply some resistance against the frame to help it shift into place.
3. Two people will be necessary at this point to assemble the trampoline. One person lifts up the circle frames. The other
person lifts the W shaped leg tubes to a standing (vertical) position and inserts the T-connectors into a U shaped leg tubes.
Ensure the locking holes arealigned.

9
Step 2: TRAMPOLINE MAT & COVER ASSEMBLY
WARNING: 2adults may be required to complete placement of all springs. Springs will create high levels of tension
when assembled. Please take care not to pinch your fingers. Ensure the holes are facing
inside.
4. Lay out the Jumping Mat (B) inside the frame.
5. put end ‘a’of the spring into trampoline Jumping Mat (B) rings, then take Spring (E) and insert end ‘b’ into Top rail tube.

10
6. Hold Spring Tool (H) overhand and pull spring hook towards Top rail (C) as picture shown; drop hook into frame
hole until it latches on completely, tap it down if hook is not completely in thehole.
Important:
Springs must be assembled on top rail in this right way around, and fully inserted into the hole on the top of the frame.
TOP TIP!
The placement of the next spring must be on the opposite side of frame, then center adjacent, then opposite. It must be
done this way so the tension of the spring is spread equality.
7. Lay Frame Cover (A) on outer edge, so springs are covered. It should be fitted like a shower cap. Please ensure it
covers all metalparts.
8. Tie the strap located at the under side of the Frame Cover to frame. Do not tie them to the springs.
Trampoline Ladder Assembly
Item No.
Part
Quantity
Item No.
Part
Quantity
1 Ladder Step 2 pcs 4 Bolt 4 pcs
2 Frame Leg 2 pcs
3 Nut 4 pcs
1) Place the two Frame Leg (2) on a clear area. Then, place one of the Ladder Steps (1) onto the bottom of each Frame Leg.
Next, slide the step up until the top bolt holes of the legs and steplineup.
Note: Make sure the checkered pattern of step is facing up.
2) Insert two Bolts (4) through the Ladder Step (1) and Frame Legs (2). Then, tighten one Nut (3) on the back of each Bolt
by Screwdriver.
3) Repeat steps 1 and 2 to assemble the second ladderstep.