amber connect Amber Covert C300 User manual

1. Accessories
Device
Charging cable
Relay
User manual
2. Specification
3. LED Indications
Dimension
78.0*41.0*13.0mm
Weight
38g
Voltage Range
7.5-90V
Backup Battery
270mAh/3.7V
Operation Temperature
-20°C to +70 °C
Humidity
20% to 80%
Standby Time
50 hours
GSM Frequencies
850/900/1800/1900 MHz
GPRS
Class 12, TCP/IP
GPS Channel
66
GPS Sensitivity
-165dBm
Acquisition Sensitivity
-148dBm
Position Accuracy
<10m
TTFF (Open sky)
Cold start <45s, Hot start <2s
GSM/GPS Antenna
Built-in design
LED Indicator
GSM-green, GPS-blue, Power-red
Data Transmit
TCP, SMS
Geo-fence
Alarm activated when the vehicle enters or leaves the specified
area
Speeding Alarm
Alarm activated when speed goes higher than the pre-set value
Low Power Alarm
Alarm activated when backup battery is running out.
Non-movement Detection
Movement alarm activated by built-in 3D motion sensor
Mileage Report
Track by time/distance interval
Remote engine
mobilization/immobitization
Mobilize/immobilize engine
GPS LED Indicator –RED
Flashing
Low battery
Slow flashing
Fully charged/ functioning normally
Solid red
Charging
Off
Power off or low battery

4. Getting Started
Please follow the instructions below to ensure safe and correct use of your device.
Note: Please ensure that there is enough credit on your SIM card. If you will be using the GPRS
function, pay attention to the current SIM card GPRS charge.
4.1.Switchon
Begin by assembling and setting up your device before its first use.
1. Open the SIM card cover.
2. Insert the SIM card.
3.Turn the battery switch to ON.
4.Close the SIM card cover and connect the device to the external power line, which will be
used to charge the terminal and built-in battery.
4.2. Switch off
1.Toggle the battery switch to OFF.
4.3. Charge the device
Plug in the device to connect or plug in the charging cable. The charging cable with 2A FUSE for
short-circuit over current protection.
GPS LED Indicator –BLUE
Flashing (interval 0.1s)
Searching for BD/GPS signal
Solid blue
BD/GPS positioned
Off
GPS asleep or off
GPS LED Indicator –GREEN
Quick Flashing
GSM initializing
Slow flashing
Receiving GSM signal normally
Solid green
Connected to GPRS network
Off
No GSM signal or no SIM card

4.4. Installing the device
Find a location inside the vehicle where the device will not be found. Your device has a built-in
GSM antenna and a GPS antenna. During installation, please ensure that the device is facing up:
Under the dashboard below the front windshield.
In the parcel shelf the rear.
In the front bumper (non-material face), ensure the device does not get wet.
Under the wiper version (non-metal), ensure the device does not get wet.
Non covert installation: affix the device to the dashboard below the windshield.
4.5. Device wiring
4.5.1. The standard voltage is 9V-90V; the red wire
is the positive and the black wire is the negative
4.5.2. Connect the black wire ground.
4.6. Device wiring diagram
Subject to permissible laws in your country.
Play close attention to the diagram description; the
battery is 9-90V and the relay rema ins 12V / 24\/.

4.7.
Power/ACC/Tele-cut-off (petrol/electricity) control line (4 pin)
4.7.1. Your device comes with a power cord and is designed to use only manufacturer- specified
wiring accessories. The re line is positive while the black is negative (this side should not be
connected to the ground wire).
4.7.2. The ACC line (orange) connects to the ACC switch of the vehicle. Please be sure to
connect to the ACC line, otherwise the device will not detect ignition status.
4.7.3. Engine immobilization (petrol/electricity) control line (yellow) is connected to pin 86 Tele-cut-
off (petrol/electricity) relay (equal to the yellow line of the relay socket)
5. Troubleshooting
Problem
Causes
Solutions
Red LED does
not work when
power is
connected
Blown fuse
Replace the fuse
Fail to connect to
network
Wrong installation of SIM card
Check SIM card installation
(install SIM card)
Debris on the Sim card’s iron surface
Clean SIM card surface
Nonfunctioning SIM
Contact internet service provides
Beyond GSM service area
Re-locate to GSM service area
Bad signal
Re-try in an area with better signal
Fail to charge
The voltage is unsuitable
Connect to power with suitable
voltage
Improper connection
Check connection with charger