ControlCenterTM ADCC0200 and ADCC0300
Keyboard Quick Reference Guide
1
Keyboard Settings
The default setting for the keyboard is RS485 mode at 19200 baud. To change these settings
enter the Special Config menu by pressing SHIFT ( ) and CLEAR ( ) keys within five
seconds of powering up the keyboard. Then press one of the following:
to change baud rate.
to change the mode (ADNet RS485 RS232).
to select Auto Repeat or Make/Break mode. See the matrix manual for correct setting.
to enable/disable the speaker.
Standard Matrix Operations
FEATURE KEYBOARD COMMAND ADCC0200 ADCC0300
RS485 RS232 RS485 RS232
Select Monitor Monitor number ® üü ü ü
Select Camera Camera number ® üü ü ü
Select Matrix/Site Site number ® AND üü ü ü
Telemetry Enable/Disable üû ü û
Pan Left/Right oystick Left/Right üü ü ü
Tilt Up/Down oystick Up/Down üü ü ü
Zoom In (or Twist oystick Clockwise) üü ü ü
Zoom Out (or Twist oystick Anti-CW) üü ü ü
Focus Near üü ü ü
Focus Far üü ü ü
Iris Open üü ü ü
Iris Close üü ü ü
Flip üü ü ü
Engage Auto Iris AND , , or üü ü ü
Engage Auto Focus AND , , or üü ü ü
Select Preset Preset number ® üü ü ü
Record Preset ® Preset number ® üû ü ü
Manually Trigger Alarm ® Alarm number ® üû ü û
Acknowledge Alarm üü ü ü
Select Sequence Sequence number ® üü ü ü
Select View View number ® üû ü û
Select Salvo Salvo number ® AND ûü û ü
