American Furniture Classics Gunfather User manual

Base Unit
Barrel Rest
Butt Rest
Top Shadow Panel
Bottom Shadow Panel
(20) Panel Screws
(12) Wood Dowels
(2) sets of Keys
(2) Hinge Pins
(8) Cam bolts
(8) Cam inserts
Top Unit
Back
Panel
Left Side Panel
(without hinge)
Right Side Panel
(with hinge)
Front Door
Verify all parts are included.
Carefully open your box and lay all of the parts out on a
at surface. Verify all parts shown below are included.
Tools Needed: Screwdriver
In the event of missing or damaged parts, please contact us at:
Phone [phone] or Fax [phone]
[e-mail]
ASSEMBLY INSTRUCTIONS
The Gunfather™

Place the Base Unit in a location with
enough room to walk around. Screw (4) cam
bolts into the (4) threaded holes in the top
of the Base Unit. Do not overtighten.
Insert 8 cam inserts
into pre-drilled holes
in both Side Panels
making sure arrows
on cams are pointing
toward the ends of
panels.
Install the Left Side Panel (Panel without
hinges) onto the (2) cam bolts on the Base
Unit and tighten cams (1/2 turn clockwise).
Insert supplied dowels into both ends of
Shadow Panels and Barrel Rest and attach to
Left Side Panel as shown here.
This side pointing out
to allow for cam bolt to
slide into!
1
3
2
4
Base
Left Side Panel
Insert Barrel Rest into
Left Side Panel
Insert Top Shadow
Panel into Left Side
Panel
Insert Bottom
Shadow Panel into
Left Side Panel

7) Insert Backpanel
inside the grooved
edges and attach using
screws. Take care that
unit is square before
attaching screws.
Install Right Side Panel to Base Unit, making sure Shadow Panels and Barrel Rest are
properly lined up, and then tighten cams (1/2 turn clockwise) to secure the Side Panel.
Attach (4) Cam Bolts to underside of Top
Unit (Do not overtighten), and carefully
attach Top Unit to the side panels.
Tighten cams (1/2 turn clockwise).
Lay Top Unit on its side
to insert and tighten
Cam bolts.
Top Unit
Side Panel
7
5
6
Top Unit
Base
Right Side Panel
Insert Barrel Rest into
Right Side Panel
Insert Top Shadow
Panel into Right
Side Panel
Insert Bottom
Shadow Panel into
Right Side Panel

Gunfather™
Attach Front Door
with supplied
(2) Hinge Pins by
aligning pre-attached
hinges on the Door
with corresponding
hinges on the the
Right Side Panel.
Attach Butt Rest to Base with double-sided
tape up. Make sure Butt Rest is up against
Shadow Panel as shown here.
Assembly is now completed!
Enjoy your new
Clock
8 9
P.O. Box 111, Webb City, MO 64870
Phone [phone] or Fax [phone]
[email protected]